Delphi TD5082W Suspension Stabilizer Bar Bushing Kit - Front To Frame

Delphi TD5082W Front Stabilizer Bar Bushing Kit

Restore front suspension support with the Delphi TD5082W suspension stabilizer bar bushing kit. This standard replacement rubber bushing is made for front-to-frame mounting and is sized for a 7/8" diameter stabilizer bar on a wide range of classic GM and Mopar applications.

Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, with dimensional and material analysis used to support proper fit and consistent performance. The TD5082W is built for drivers servicing vehicles such as Chevrolet Camaro, Pontiac Firebird, and Buick Skylark front suspension systems.

Key Features

• Rubber construction for standard replacement service
• Inside diameter: 0.813 in.
• Front to frame position
• Fits 7/8" diameter suspension stabilizer bar applications
• OE-focused design approach from Delphi
• Part number: TD5082W

Detailed Description

The Delphi TD5082W is a front stabilizer bar bushing kit designed for vehicles using a 7/8" front sway bar at the frame mount. It serves as a direct replacement option for many GM A-body, F-body, and related platforms, including Chevrolet Camaro, Pontiac Firebird, Oldsmobile Cutlass, and Buick Regal applications. This part cross-references MOOG Chassis Products K5241 for the same application.

Delphi validates parts through temperature exposure below -40 degrees C and above 120 degrees C, along with extended salt-spray testing, to help confirm material durability in demanding service conditions. The TD5082W part number is also listed among multiple interchange references for this application family.

What This Part Helps Address

• Front sway bar movement at the frame mount
• Clunking or squeaking from worn stabilizer bar bushings
• Excessive play in the front suspension stabilizer bar
• Reduced steering response caused by deteriorated rubber bushings
• Noise and vibration from aged front suspension components

Installation Notes and Tips

Confirm the stabilizer bar diameter before ordering; this bushing is specified for a 7/8" bar and front-to-frame placement. Inspect the sway bar, frame mount, and surrounding hardware for wear or corrosion before installation, and replace any damaged mounting surfaces as needed. Verify vehicle fitment by year, make, model, and position before service.

Quality Assurance

Delphi uses OE-based testing and dimensional analysis to support fit and durability in aftermarket steering and suspension parts. The TD5082W is engineered as a standard replacement bushing for front stabilizer bar service on supported applications.