Delphi TD5117W Suspension Stabilizer Bar Bushing Kit - Rear or Rear To Frame

Delphi Rear Stabilizer Bar Bushing Kit

Restore rear sway bar support with this Delphi suspension stabilizer bar bushing kit, part number TD5117W. Built as a standard replacement with black rubber construction, it is made for rear and rear-to-frame applications on select BMW models, including BMW 128i, 135i, 135is, 328i, 335i, 535i xDrive, 535xi, and 530xi.

Delphi applies OE-focused dimensional and material analysis to help maintain proper fit and consistent suspension performance. Part number TD5117W is engineered for vehicles using a 12 mm rear bar diameter where noted in the fitment data.

Key Features

• Black rubber bushing material for suspension support
• Standard replacement grade for rear stabilizer bar service
• Designed for rear and rear-to-frame mounting locations
• Inside diameter: 10.0 mm / 0.393 in
• Width: 42.5 mm / 1.673 in
• Height: 45.8 mm / 1.803 in
• No grease fitting included
• No mounting hardware included

Detailed Description

Delphi TD5117W is a suspension stabilizer bar bushing kit for rear sway bar mounting points on select BMW applications. It is built from rubber and sized to match OE-style dimensions, helping maintain the correct interface between the stabilizer bar and its mounting location. This part cross-references Monroe Shocks & Struts (e.g., K201032) for the same application.

Compatible With 2008-2013 BMW 128i, rear to frame; 2008-2013 BMW 135i, rear to frame; 2013 BMW 135is, rear; 2011-2013 BMW 328i, rear with 12mm bar diameter; 2011-2013 BMW 335i, rear with 12mm bar diameter; 2007-2010 BMW 328i, rear with 12mm bar diameter; 2009-2010 BMW 535i xDrive, rear with 12mm bar diameter; 2008 BMW 535xi, rear with 12mm bar diameter; and 2006-2007 BMW 530xi, rear with 12mm bar diameter.

What It Helps Address

• Rear sway bar movement caused by worn bushings
• Clunking or knocking from the rear suspension area
• Excess play at the stabilizer bar mounting point
• Reduced bar support from cracked or hardened rubber
• Fitment issues when replacing an OE-style rear bushing

Installation Notes and Tips

Verify the rear stabilizer bar diameter before ordering, especially on BMW 328i, 335i, 535i xDrive, 535xi, and 530xi applications listed with a 12 mm bar diameter. Confirm whether your vehicle uses a rear or rear-to-frame mounting position, and compare the original bushing dimensions to TD5117W before installation. Because mounting hardware is not included, reuse or replace related fasteners as needed during service.

Quality Assurance

Delphi tests this OE-style replacement through temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability in demanding conditions. The brand also uses dimensional and material analysis to support OE-level fit consistency for the aftermarket suspension application.