Delphi TD529W Suspension Stabilizer Bar Bushing Kit - Front

Delphi TD529W Front Stabilizer Bar Bushing Kit

Restore front suspension control with the Delphi TD529W stabilizer bar bushing kit. Built with rubber construction and OE-focused dimensional analysis, this front sway bar bushing is made for Volkswagen Cabrio, Golf, Jetta, and Corrado applications that use a 17 mm front bar diameter.

Delphi TD529W is a standard replacement suspension stabilizer bar bushing kit for front-position service. It is engineered for consistent OE-style fitment and is tested across extreme temperature and corrosion conditions to support dependable performance in everyday driving.

Key Features

• Rubber bushing material with black finish
• Front-position stabilizer bar bushing kit
• Inside diameter: 17.5 mm / 0.689 in
• Outside diameter: 34.0 mm / 1.339 in
• Standard replacement, regular grade
• OE-based dimensional and material analysis for fit consistency
• Delphi TD529W part number for easy identification

Vehicle Fitment

• Fits 1995-2002 Volkswagen Cabrio, front
• Fits 1985-2001 Volkswagen Golf, front, with 17mm bar diameter
• Fits 1993-1999 Volkswagen Jetta, front
• Fits 1992-1995 Volkswagen Corrado, front
• Fits 1984-1992 Volkswagen Jetta, front, with 17mm bar diameter
• Fits 1990-1991 Volkswagen Corrado, front, with 17mm bar diameter

Detailed Description

The Delphi TD529W stabilizer bar bushing kit is built for front suspension service where the sway bar must stay centered and properly isolated from the chassis. Its rubber construction helps maintain the correct interface between the bar and mounting points, supporting stable handling feel on Volkswagen Cabrio, Golf, Jetta, and Corrado models. If you are replacing worn front sway bar bushings on a Volkswagen Golf or Volkswagen Jetta, Delphi TD529W provides a direct-fit replacement option for the specified 17 mm bar applications.

This part cross-references Mevotech Supreme MK90009 for the same application.

Common Problems It Can Help Address

• Front suspension clunking or rattling from worn stabilizer bushings
• Excessive sway bar movement at the mounting points
• Loose or imprecise front-end handling feel
• Noise caused by hardened, cracked, or compressed rubber bushings
• Uneven stabilizer bar support on Volkswagen front suspension systems

Installation Notes and Quality Assurance

Verify the front stabilizer bar diameter before installation to confirm the 17 mm application match. Inspect the sway bar and mounting surfaces for wear or corrosion before fitting the new bushings, and replace any damaged components as needed for proper alignment and contact.

Delphi applies OE-focused engineering and validation to its aftermarket steering and suspension portfolio. This bushing is evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and for extended salt-spray exposure to support durability in demanding conditions. Delphi TD529W is backed by the brand’s OE-based design and testing approach.