Delphi TD5535W Suspension Stabilizer Bar Bushing Kit - Front To Frame

Delphi Front Stabilizer Bar Bushing Kit

Delphi TD5535W is a standard replacement suspension stabilizer bar bushing kit built for front-to-frame applications. It is made from black rubber and sized for a 25.8 mm inside diameter, with dimensions that support a precise OE-style fit on the vehicle’s sway bar mounting point.

Fits 2005-2009 Ford Mustang, front to frame, with 26mm diameter sway bar. This Delphi TD5535W bushing kit is a direct-fit option for Ford Mustang suspension service where the original front stabilizer bar bushings have worn, hardened, or lost shape.

Key Features

• Brand: Delphi
• Part number: TD5535W
• Suspension stabilizer bar bushing kit for front-to-frame mounting
• Black rubber construction for standard replacement service
• Inside diameter: 25.8 mm
• Dimensions: 31.0 mm width, 57.25 mm height
• Grade type: Regular; item grade: Standard Replacement

Detailed Description

Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, using dimensional and material analysis to support proper part-to-vehicle compatibility. TD5535W is designed for the front-to-frame stabilizer bar location on 2005-2009 Ford Mustang models equipped with a 26 mm diameter sway bar. The rubber construction helps restore the stabilizer bar’s mounting interface and maintain consistent bar location under normal suspension movement.

This part cross-references Ford 4R3Z-5493-AA and MOOG Chassis Products K201532 for the same application. Use Delphi TD5535W when replacing front sway bar bushings on a Ford Mustang and you need a standard replacement part that matches the OE-style dimensions.

What It Helps Address

• Clunking or knocking from the front suspension area
• Excessive sway bar movement at the frame mount
• Worn, cracked, or hardened stabilizer bar bushings
• Loose-feeling front-end handling caused by bushing wear
• Noise during cornering or over uneven pavement

Installation Notes and Tips

Confirm the sway bar diameter before ordering; this part is specified for a 26 mm diameter sway bar on the listed Ford Mustang applications. Inspect the stabilizer bar and frame mounting surfaces for wear, corrosion, or deformation before installation. Clean the contact area thoroughly so the new rubber bushing seats correctly at the front-to-frame position.

Quality Assurance

Delphi subjects its OE-based aftermarket parts to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and 720 hours of salt spray. That testing supports consistent material performance for suspension service on the listed Ford Mustang applications.