Delphi TD5594W Suspension Stabilizer Bar Bushing Kit - Front

OE-Style Front Stabilizer Bar Bushing Kit

Delphi TD5594W is a front suspension stabilizer bar bushing kit built for OE-style replacement on select Toyota Prius models. It uses natural rubber construction to help maintain bar control and consistent suspension feel in everyday driving.

Fits 2001-2004 Toyota Prius, front. This part cross-references Beck/Arnley 101-8108 for the same application.

Key Features

• Natural rubber (NR) construction for OE-style compliance and road isolation
• Black finish
• Front position application
• Standard replacement grade
• Inside diameter: 20.0 mm (0.787 in)
• Width: 1.575 in; height: 34.0 mm (1.339 in)
• No grease fitting included
• No mounting hardware included

Detailed Description

Delphi TD5594W is a suspension stabilizer bar bushing kit engineered for the front sway bar on 2001-2004 Toyota Prius models. Delphi applies OE-focused dimensional and material analysis to aftermarket steering and suspension parts, helping support proper fit and consistent performance. The natural rubber bushing material is selected for standard replacement use where factory-style compliance and noise control matter.

For buyers searching for a front sway bar bushing kit for Toyota Prius 2001-2004, Delphi TD5594W provides an OE-style service part that matches the application requirements of the original front stabilizer bar setup. The part number TD5594W is also useful when cross-checking catalog listings and interchange references.

What It Helps Address

• Front suspension clunking from worn stabilizer bar bushings
• Excess sway bar movement at the front axle
• Loose or imprecise steering feel caused by deteriorated bushing material
• Noise and vibration from aged rubber suspension components
• Restoration of factory-style front anti-roll bar support

Installation Notes and Tips

Install TD5594W on the front stabilizer bar location specified for 2001-2004 Toyota Prius. Inspect the sway bar, brackets, and surrounding suspension components before installation, since worn hardware or corrosion can affect bushing performance. Verify the 20.0 mm inside diameter and overall dimensions against the removed part before service.

Quality Assurance

Delphi subjects its OE-based aftermarket parts to temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. That OE validation approach supports consistent material performance for front suspension service on Toyota Prius applications.