Delphi TD5622W Suspension Stabilizer Bar Bushing Kit - Rear

Rear Stabilizer Bar Bushing Kit for Honda CR-V

Delphi TD5622W is a rear suspension stabilizer bar bushing kit built for OE-style replacement on select Honda CR-V models. It is engineered for the rear position and uses a standard replacement design with a black finish, 16.5 mm inside diameter, and compact bushing dimensions for a precise suspension fit.

Compatible with 2012-2014 Honda CR-V rear applications, this Delphi stabilizer bar bushing kit supports consistent sway bar mounting and helps restore proper rear suspension feel. Delphi applies OE-level dimensional and material analysis to aftermarket steering and suspension parts, with testing that includes extreme temperature exposure and salt spray resistance.

Key Features

• Part number: TD5622W
• Rear stabilizer bar bushing kit
• Standard replacement grade
• Black bushing construction
• Inside diameter: 16.5 mm (0.65 in.)
• Width: 1.496 in.; height: 1.614 in. (41.0 mm)
• No grease fitting included
• No mounting hardware included

Detailed Description

Delphi TD5622W is a rear suspension stabilizer bar bushing kit for the 2012-2014 Honda CR-V. It is built to match OE-style dimensions and material requirements, helping maintain proper stabilizer bar location at the rear of the vehicle. The bushing’s 16.5 mm inside diameter and standard replacement construction make it a direct-fit service part for the specified application.

Delphi’s OE background is reflected in its aftermarket steering and suspension portfolio, with parts validated through temperature testing below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray exposure. This part cross-references MOOG Chassis Products K201299 for the same application. TD5622W is also associated with OE reference 52306-T0A-A01.

What This Part Helps Address

• Rear sway bar movement caused by worn bushings
• Clunking or rattling from the rear suspension area
• Excessive play at the stabilizer bar mounting point
• Reduced rear-end stability from deteriorated bushing material
• Uneven suspension response on Honda CR-V rear applications

Installation Notes and Tips

Install TD5622W at the rear stabilizer bar location on 2012-2014 Honda CR-V models. Inspect the stabilizer bar, brackets, and surrounding hardware before installation, since mounting hardware is not included. Clean the contact surfaces thoroughly and verify the bushing dimensions match the vehicle application before assembly.

Quality Assurance

Delphi validates this suspension bushing through OE-focused dimensional and material analysis, along with environmental testing for heat, cold, and corrosion exposure. The result is a standard replacement part built to meet the demands of rear suspension service on the Honda CR-V.