Delphi TD5632W Suspension Control Arm Bushing - Rear Forward or Rear Lower Outer

Delphi TD5632W Suspension Control Arm Bushing

Delphi TD5632W is a standard replacement suspension control arm bushing built with natural rubber and steel for OE-style fit and function. It is compatible with 2003-2004 INFINITI M45 applications in the rear lower outer and rear forward positions.

Key Features

• Natural rubber (NR) and steel construction
• Press-in mounting type for the specified suspension location
• Gray finish
• Standard replacement item grade
• Engineered from Delphi OE dimensional and material analysis
• Tested for temperature extremes below -40°C and above 120°C
• Exposed to 720 hours of salt spray testing

Application Details

This Delphi TD5632W bushing is made for rear suspension control arm service on 2003-2004 INFINITI M45 models. Use it for the rear lower outer or rear forward position as listed for your vehicle. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Excessive play in the rear control arm mounting point
• Clunking or knocking from worn suspension bushings
• Loose rear suspension feel during braking or cornering
• Uneven tire wear caused by degraded bushing support
• Loss of alignment stability from deteriorated rubber components

Installation Notes

TD5632W uses a press-in mounting design and does not include mounting hardware. Confirm the exact rear position on your INFINITI M45 before installation, since this part is listed for rear lower outer and rear forward locations. Professional installation and a suspension alignment after replacement are recommended.

Quality Assurance

Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio. This bushing is built using dimensional and material analysis to match OE requirements and is validated through temperature and corrosion testing for demanding service conditions.