Delphi TD5651W Suspension Stabilizer Bar Bushing Kit - Front

Delphi TD5651W Front Stabilizer Bar Bushing Kit

Restore front suspension control with the Delphi TD5651W stabilizer bar bushing kit. Built as a standard replacement for OE-style service, it supports the front sway bar on select Toyota Prius, Toyota Prius Plug-In, Scion tC, and Toyota RAV4 applications.

Delphi applies OE-focused dimensional and material analysis to help maintain proper fit and consistent suspension performance. The black bushing is specified with a 21.0 mm inside diameter, 61.0 mm height, and 2.48 in. width for front stabilizer bar service.

Key Features

• Front suspension stabilizer bar bushing kit
• Standard replacement grade for OE-style service
• Black bushing construction
• 21.0 mm inside diameter for the listed applications
• Designed for front-position use on select Toyota and Scion vehicles
• Delphi OE-based dimensional and material analysis for fit consistency
• Part number TD5651W for easy lookup

Application Details

Compatible with front stabilizer bar service on 2011-2016 Scion tC, 2010-2015 Toyota Prius, 2012-2015 Toyota Prius Plug-In, and 2006-2008 Toyota RAV4 except 3 rows of seats. This Delphi TD5651W bushing kit is a direct-fit suspension service part for vehicles that need front sway bar isolation and support.

This part cross-references MOOG Chassis Products K201482 for the same application.

What It Helps Address

• Front end clunking from worn stabilizer bar bushings
• Excess sway bar movement under cornering load
• Loose or imprecise steering feel caused by bushing wear
• Noise from deteriorated front suspension bushings
• Loss of suspension isolation at the front stabilizer bar

Installation Notes

• Verify the front stabilizer bar diameter and vehicle application before installation.
• Inspect the sway bar, brackets, and surrounding suspension components for wear before replacing the bushing.
• Mounting hardware is not included.
• Grease fitting is not included.
• Professional installation is recommended for proper suspension service and alignment checks after repair.

Quality Assurance

Delphi subjects steering and suspension components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. The TD5651W is built to support OE-level compatibility through detailed dimensional and material analysis.