Delphi TD5681W Suspension Stabilizer Bar Bushing Kit - Front

Delphi Front Stabilizer Bar Bushing Kit

Delphi TD5681W is a front suspension stabilizer bar bushing kit built with rubber and standard replacement specifications. It is made for front-to-frame and front sway bar service on select Mitsubishi applications, including Mitsubishi Lancer and Mitsubishi Mirage fitments.

• Rubber construction for stabilizer bar support and vibration isolation
• Inside diameter: 0.787 in.
• Standard replacement grade for OE-style service
• Front position fitment for frame-mounted and front sway bar applications
• Delphi part number TD5681W for direct catalog lookup

Fitment Details

Compatible With select Mitsubishi suspension applications:

• Fits 2008-2017 Mitsubishi Lancer, Front To Frame
• Fits 1993-1996 Mitsubishi Mirage, Front, with 20mm Diameter Sway Bar

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Application Overview

Use Delphi TD5681W when servicing a worn front stabilizer bar bushing on a Mitsubishi Lancer or Mitsubishi Mirage. The rubber bushing helps maintain sway bar location at the front suspension, supporting consistent bar movement and reducing unwanted play at the mounting point. Delphi applies OE dimensional and material analysis to improve part-to-part compatibility between original equipment and aftermarket replacement needs.

• Front sway bar movement at the frame mount
• Clunking or looseness from worn stabilizer bar bushings
• Excessive suspension noise over bumps and uneven roads
• Reduced bar control caused by deteriorated rubber
• Fitment concerns on front stabilizer bar service for Mitsubishi Lancer and Mitsubishi Mirage

Installation Notes

Verify the sway bar diameter before installation, especially on 1993-1996 Mitsubishi Mirage applications that require a 20 mm diameter sway bar. Confirm front mounting location and compare the old bushing to the replacement part number TD5681W before service. Clean the mounting surface and inspect the stabilizer bar and brackets for wear before reassembly.

Quality Assurance

Delphi subjects its OE-based steering and suspension components to temperature extremes below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray testing. That validation supports durability checks for front suspension service on Mitsubishi Lancer and Mitsubishi Mirage applications.