Delphi TD5694W Suspension Control Arm Bushing - Rear Upper

OE-Style Rear Upper Control Arm Bushing

Delphi TD5694W is a standard replacement suspension control arm bushing for the rear upper position on select Honda Accord models. Built with a rubber-steel construction, it is made for direct-fit service where a pressed bushing is required.

Fits 2003-2007 Honda Accord, rear upper. This Delphi bushing is engineered using OE dimensional and material analysis to support proper fit and consistent suspension performance on the Honda Accord rear upper control arm.

Key Features

• Rubber-steel construction for controlled compliance and durability
• Pressed mounting type for applications that require bushing installation into the control arm
• Standard replacement grade for routine suspension service
• Gray finish
• Dimensions: 1.969 in. length, 0.48 in. inside diameter, 1.642 in. outside diameter
• Fits the rear upper position on 2003-2007 Honda Accord

Detailed Description

Delphi TD5694W suspension control arm bushing is built for the rear upper location on 2003-2007 Honda Accord models. Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, using dimensional and material analysis to match the original part as closely as possible. The rubber-steel design helps provide the balance of support and isolation expected in a control arm bushing, while the pressed fit supports a factory-style service replacement.

This part cross-references MOOG Chassis Products RK621873 for the same application. Delphi TD5694W is also referenced in the aftermarket under related numbers used for the Honda Accord rear upper control arm bushing application.

What This Part Helps Address

• Rear suspension looseness or excess movement at the control arm pivot
• Clunking or knocking from worn bushing material
• Uneven tire wear caused by suspension geometry changes
• Imprecise rear suspension response during braking or cornering
• Visible cracking, separation, or deterioration in the original bushing

Installation Notes and Tips

This is a pressed bushing, so installation typically requires removal of the control arm and use of a suitable press or bushing service tool. Inspect the rear upper control arm, surrounding hardware, and alignment condition before reassembly. Because this part is position-specific, confirm rear upper fitment for your 2003-2007 Honda Accord before ordering. Delphi TD5694W should be installed in accordance with factory service procedures for the vehicle.

Quality Assurance

Delphi subjects its OE-based suspension components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. That testing approach supports consistent material performance and fitment confidence for the Honda Accord rear upper control arm bushing application.