Delphi TD5697W Suspension Control Arm Bushing - Front Right Lower Rearward

OE-Style Control Arm Bushing for Front Suspension

Delphi TD5697W is a suspension control arm bushing built for the front right lower rearward position on select Dodge Durango and Jeep Grand Cherokee models. It uses a rubber-aluminium construction and OE-based dimensional analysis to support proper fit and suspension alignment.

Fits 2011-2015 Dodge Durango, front right lower rearward. Fits 2011-2015 Jeep Grand Cherokee, front right lower rearward.

Key Features

• Part number: TD5697W
• Suspension control arm bushing for front right lower rearward placement
• Rubber-aluminium material construction
• Standard replacement grade
• Pressed + bolt-on mounting type
• Inside diameter: 30.0 mm (1.181 in)
• Outside diameter: 85.0 mm (3.346 in)
• Length: 200.0 mm (7.874 in)
• Wall thickness: 16.0 mm (0.63 in)
• Distance between mounting holes: 161.7 mm (6.366 in)

Detailed Description

Delphi TD5697W is engineered as a direct-fit suspension control arm bushing for the front right lower rearward location on 2011-2015 Dodge Durango and 2011-2015 Jeep Grand Cherokee applications. Delphi applies OE-level dimensional and material analysis to help ensure proper compatibility between the original suspension geometry and the replacement part. The rubber-aluminium design supports the control arm mounting point while maintaining the fit and isolation characteristics expected in a standard replacement bushing. This part number, TD5697W, is also referenced in OE and aftermarket cross listings for the same application.

This part cross-references Dorman - OE Solutions 524-056 for the same application.

What It Helps Address

• Excessive play or looseness at the front control arm mounting point
• Clunking or knocking from worn suspension bushings
• Uneven tire wear related to suspension movement
• Steering feel changes caused by deteriorated bushing support
• Alignment instability after bushing wear

Installation Notes and Tips

TD5697W uses a pressed + bolt-on mounting style, so installation typically requires proper suspension support and the correct press or service tools for the control arm assembly. Verify the front right lower rearward position before removal, and compare the original bushing dimensions to the replacement part number TD5697W to confirm match-up on your Dodge Durango or Jeep Grand Cherokee. Because this is a suspension component, a professional alignment check is recommended after installation.

Quality Assurance

Delphi tests OE-style steering and suspension components under extreme temperature and corrosion conditions, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. That validation process, along with dimensional and material analysis, supports consistent fit and performance for replacement use.