Delphi TD5718W Suspension Control Arm Bushing - Front Right Lower

OE-Style Front Right Lower Bushing

Delphi TD5718W is a suspension control arm bushing for the front right lower position on select Nissan Sentra models. Built with a rubber-steel construction and standard replacement dimensions, it supports precise suspension location and consistent control arm movement.

Compatible With 2007-2012 Nissan Sentra, front right lower. Delphi TD5718W is sized for pressed-in mounting and matches OE-style dimensional and material requirements for a direct replacement service part.

Key Features

• Part number: TD5718W
• Suspension control arm bushing for the front right lower position
• Rubber-steel construction for controlled flex and support
• Pressed mounting type for OE-style installation
• Standard replacement grade
• Gray finish
• Dimensions: 53.0 mm length, 12.2 mm inside diameter, 58.0 mm outside diameter
• Fits 2007-2012 Nissan Sentra, front right lower

Detailed Description

Delphi TD5718W is engineered as a suspension control arm bushing for the front right lower location on 2007-2012 Nissan Sentra applications. The rubber-steel design helps isolate road vibration while maintaining the control arm’s position under load, which is important for stable steering response and suspension geometry. Delphi applies OE-focused dimensional and material analysis to help ensure proper fit and function in the aftermarket. This part cross-references MOOG Chassis Products (e.g., K201336, K500223) for the same application.

Common Repair Uses

• Restoring worn control arm bushing support
• Reducing clunking or looseness from deteriorated suspension bushings
• Addressing uneven tire wear caused by suspension movement
• Improving front-end stability on a Nissan Sentra
• Replacing a pressed bushing with OE-style dimensions

Installation Notes and Tips

This bushing uses a pressed mounting design, so removal and installation typically require a hydraulic press or appropriate bushing service tools. Inspect the control arm, mounting surfaces, and adjacent suspension components before installation. Verify the front right lower position and confirm dimensions against the original part before pressing in the new bushing.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to extreme temperature testing from below -40 degrees C to above 120 degrees C, along with 720 hours of salt spray exposure. That testing supports durability expectations for daily driving conditions and corrosion resistance in demanding environments.