Delphi TD5745W Suspension Control Arm Bushing - Front Lower Arm To Strut

Delphi TD5745W Front Lower Arm Bushing

Delphi TD5745W is a suspension control arm bushing built for the front lower arm to strut position on select Mazda 6 models. It uses natural rubber construction and press-in mounting to match OE-style suspension service needs for 2009-2013 Mazda 6 applications.

Delphi applies OE-focused dimensional and material analysis to help ensure proper part-to-vehicle matching. This bushing is a standard replacement for drivers servicing front suspension wear on a Mazda 6, with the Delphi TD5745W part number used for direct identification in catalog and repair searches.

Key Features

• Suspension control arm bushing for the front lower arm to strut location
• Natural rubber (NR) construction for OE-style compliance and ride isolation
• Press-in mounting type for service replacement applications
• Standard replacement grade for front suspension repair
• Black finish with measured dimensions: 49.4 length, 49.4 width, 44.3 outside diameter, and 12.4 inside diameter
• Delphi TD5745W part number for accurate ordering and lookup

Detailed Description

Delphi TD5745W is engineered as a front suspension control arm bushing for the front lower arm to strut position on 2009-2013 Mazda 6 models. The natural rubber material supports the compliance and isolation expected in a suspension bushing, while the press-in design matches common OE service procedures. Delphi’s OE background and dimensional/material analysis help support fitment consistency between original and aftermarket replacement parts. This part cross-references Beck/Arnley 102-7849 and Dorman - Premium CB65183PR for the same application.

Use Delphi TD5745W when replacing a worn front lower arm bushing on a Mazda 6 to restore suspension joint support and maintain proper arm-to-strut location. The Delphi TD5745W part number is also useful when searching for a direct replacement for 2009-2013 Mazda 6 front suspension service.

What This Part Helps Address

• Excessive front suspension movement from a worn control arm bushing
• Clunking or knocking noises from the front lower arm area
• Steering feel changes caused by bushing wear
• Uneven tire wear related to suspension alignment instability
• Loss of suspension isolation at the front lower arm to strut mount point

Installation Notes and Tips

Fits 2009-2013 Mazda 6, front lower arm to strut. This is a press-in bushing, so proper suspension service tools and correct bushing installation procedures are required. Inspect the surrounding control arm components, mounting surfaces, and alignment settings before and after replacement. Verify the Delphi TD5745W part number and vehicle position before installation.

Quality Assurance

Delphi tests suspension and steering components under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure plus extended salt spray testing, to support OE-level performance expectations. The brand’s OE engineering approach and material analysis are used to help maintain dimensional accuracy and application consistency for Mazda 6 front suspension service.