Delphi TD5753W Suspension Stabilizer Bar Bushing Kit - Rear

Rear Sway Bar Bushing Kit for Mercedes-Benz C-Class

Delphi TD5753W is a rear suspension stabilizer bar bushing kit built as a standard replacement for select Mercedes-Benz C-Class applications. It uses rubber construction in black and is sized for vehicles with a 13mm diameter rear sway bar, helping restore proper bar support and suspension control.

Compatible With 2001-2007 Mercedes-Benz C240, C320, C230, C280, and C350 rear applications, this Delphi TD5753W bushing kit is engineered with OE-focused dimensional and material analysis for fitment consistency.

Key Features

• Rubber bushing material for rear stabilizer bar mounting
• Black finish
• Standard replacement grade
• Inside diameter: 0.51 in.
• Outside diameter: 1.56 in.
• Width: 1.89 in.
• Height: 1.89 in.
• Fits rear applications with a 13mm diameter sway bar
• Delphi TD5753W part number for accurate ordering

Product Details

Delphi TD5753W is a rear suspension stabilizer bar bushing kit made for Mercedes-Benz C230, C240, C280, C320, and C350 models listed below. The rubber construction is intended to support the rear sway bar at the correct position and dimensions, while Delphi’s OE-oriented testing and material analysis help maintain dimensional match and material consistency for the application. If you are replacing worn rear sway bar bushings on a Mercedes-Benz C-Class with a 13mm rear sway bar, TD5753W provides a direct-fit replacement option.

This part cross-references URO 2033260381 for the same application.

Common Problems This Part Addresses

• Rear sway bar movement caused by worn bushings
• Clunking or rattling from the rear suspension area
• Reduced stabilizer bar support at the mounting point
• Loose or deteriorated rubber bushings on the rear anti-roll bar
• Fitment issues when replacing an aging Mercedes-Benz rear sway bar bushing

Installation Notes and Tips

Verify that the vehicle has a 13mm diameter rear sway bar before ordering. Confirm the rear mounting location and compare the original bushing dimensions to the listed measurements: 0.51 in. inside diameter, 1.56 in. outside diameter, 1.89 in. width, and 1.89 in. height. Inspect the sway bar and surrounding hardware for wear or corrosion before installation so the new bushing seats correctly.

Quality Assurance

Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio. This bushing kit is tested across extreme temperature ranges below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability under demanding conditions.