Delphi TD5782W Suspension Control Arm Bushing - Rear Upper

Delphi Rear Upper Control Arm Bushing

Delphi TD5782W is a standard replacement suspension control arm bushing built for rear upper applications on select Buick, Chevrolet, and Saab vehicles. It uses rubber construction and OE-focused dimensional and material analysis to support proper suspension alignment and consistent control arm movement.

Compatible with 2010-2013 Buick LaCrosse, 2011-2013 Buick Regal, 2013 Chevrolet Malibu, 2010-2011 Saab 9-5, and 2010 Buick Allure in rear upper positions, this Delphi suspension bushing is a direct-fit service part for common rear suspension wear repairs.

Key Features

• Rubber bushing construction for rear suspension control arm service
• Standard replacement grade for OE-style repair work
• Gray finish with 2.13 in. length, 1.56 in. outside diameter, and 0.56 in. inside diameter
• Built for rear left upper and rear left upper forward positions where specified by application
• Delphi TD5782W part number for accurate ordering and catalog matching
• OE-based dimensional and material analysis for fitment consistency

Detailed Description

Delphi TD5782W is a suspension control arm bushing engineered for rear upper suspension locations on select GM and Saab platforms. The rubber material helps isolate suspension movement while maintaining the control arm’s location under load. Delphi applies OE-level testing and material analysis to its aftermarket steering and suspension portfolio, including exposure to extreme temperatures and salt spray conditions to evaluate durability. For buyers searching for a rear upper control arm bushing for 2010-2013 Buick LaCrosse, 2011-2013 Buick Regal, or 2013 Chevrolet Malibu, this part number provides a focused replacement option.

This part cross-references Dorman - OE Solutions 524-215 and Mevotech Supreme CMS501170 for the same application.

What It Helps Repair

• Rear suspension looseness or excess play at the control arm pivot point
• Clunking or knocking noises from worn rear upper bushings
• Uneven rear suspension movement caused by deteriorated rubber
• Alignment instability related to worn control arm mounting points
• Ride quality changes from cracked or compressed suspension bushings

Installation Notes and Tips

Verify the rear upper position and compare the inside diameter, outside diameter, and length against the removed bushing before installation. For vehicle-specific placement, refer to the application tab and confirm whether your vehicle uses the rear left upper or rear left upper forward location. Proper suspension inspection is recommended before replacing the bushing so related wear in the control arm or mounting points can be addressed at the same time.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its aftermarket steering and suspension parts. TD5782W is tested across extreme temperature ranges and salt spray exposure to help verify material performance and dimensional consistency for the listed applications.