Delphi TD5854W Suspension Control Arm Bushing - Front Lower Outer Forward

Delphi TD5854W Suspension Control Arm Bushing

Delphi TD5854W is a front lower outer forward suspension control arm bushing built for OE-style replacement on select Chrysler, Dodge, and Mitsubishi applications. It uses rubber construction and a press-in mounting design to restore suspension joint support in the front end.

Key Features

• Rubber bushing material for standard replacement service
• Press-in mounting type for the front lower outer forward position
• Gray finish with OE-style dimensional and material matching
• Built to Delphi OE performance standards for temperature and corrosion exposure
• Part number TD5854W for accurate ordering and catalog lookup

Detailed Description

This Delphi suspension control arm bushing is engineered for the front lower outer forward location and is sized for precise fitment in the suspension assembly. Delphi applies OE-level dimensional and material analysis to help ensure proper compatibility between the original part and the aftermarket replacement. The rubber construction supports controlled suspension movement while helping maintain alignment stability and steering response. This part cross-references Dorman OE Solutions 520-357 for the same application. Fits 1995-2000 Chrysler Sebring, front lower outer forward; fits 1995-2000 Dodge Avenger, front lower outer forward; fits 1995-1998 Mitsubishi Eclipse, front lower outer forward; fits 1994-1998 Mitsubishi Galant, front lower outer forward.

Common Repair Applications

• Front suspension clunking or looseness from worn control arm bushings
• Excessive play at the front lower outer forward control arm mount
• Uneven tire wear related to suspension bushing wear
• Steering wander caused by deteriorated rubber suspension support
• Restoration of factory-style suspension geometry on Chrysler Sebring, Dodge Avenger, Mitsubishi Eclipse, and Mitsubishi Galant

Installation Notes and Tips

Install TD5854W in the front lower outer forward position using a press-in procedure. Inspect the control arm, mounting surfaces, and surrounding suspension components before installation, and replace any worn hardware or damaged parts as needed. Because this is a suspension bushing, final alignment should be checked after installation.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to verify durability under demanding conditions. The TD5854W is a standard replacement part backed by Delphi's OE-focused engineering approach.