Delphi TD752W Suspension Control Arm Bushing - Front Lower Inner

OE-Style Front Lower Inner Bushing

Delphi TD752W is a suspension control arm bushing for the front lower inner position on select Honda Accord models. Built with rubber-to-metal construction, it supports controlled suspension movement while helping maintain alignment stability and ride quality.

Compatible with 1990-1993 Honda Accord, front lower inner, this Delphi replacement is built to OE dimensional and material standards for a precise service fit. The TD752W is a standard replacement choice for restoring worn suspension pivot points on the Honda Accord.

Key Features

• Rubber-to-metal construction for suspension isolation and load control
• Press-fit mounting type for direct replacement service
• Black finish
• Standard replacement grade
• Front lower inner position
• Delphi TD752W part number for catalog matching

Detailed Description

Delphi TD752W is engineered as a suspension control arm bushing for the front lower inner location on 1990-1993 Honda Accord applications. Delphi applies OE-focused dimensional and material analysis to help ensure proper compatibility between the replacement part and the original suspension interface. The bushing measures 2.2 in. long, 0.48 in. inside diameter, and 0.242 in. wall thickness, with a press-fit design that matches the service requirements of the application. This part cross-references MOOG Chassis Products K9760 for the same application.

Common Repair Uses

• Restores worn control arm pivot support on a Honda Accord
• Addresses looseness or play at the front lower inner suspension point
• Helps reduce clunking or shifting caused by deteriorated rubber bushings
• Supports more consistent steering response and suspension geometry
• Replaces cracked, hardened, or separated OE-style bushing material

Installation Notes and Tips

This bushing uses a press-fit mounting type and does not include mounting hardware. Proper installation typically requires suspension disassembly and a suitable press tool to remove and install the bushing without damaging the control arm. Verify the front lower inner position and confirm part number TD752W against the vehicle before service. For 1990-1993 Honda Accord front lower inner applications, inspect the surrounding control arm and mounting surfaces for wear before reassembly.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. These validation steps support durability and corrosion resistance expectations for everyday service on Honda Accord suspension repairs.