Delphi TD858W Suspension Control Arm Bushing - Rear Lower Rearward

Delphi TD858W Suspension Control Arm Bushing

Delphi TD858W is a standard replacement suspension control arm bushing built for the rear lower rearward position on select Suzuki Swift models. It uses rubber construction and press-fit mounting to support consistent suspension movement and OE-style fitment for 1989-2001 Suzuki Swift applications.

Key Features

• Rubber bushing construction for suspension isolation and control
• Press-fit mounting type for the rear lower rearward control arm location
• Standard replacement grade for direct service use
• Dimensions: 10.2 mm inside diameter, 40.3 mm outside diameter, 50.0 mm height
• Built using Delphi OE-focused dimensional and material analysis
• Part number TD858W for catalog and cross-reference lookup

Detailed Description

Delphi TD858W is engineered as a suspension control arm bushing for the rear lower rearward position on 1989-2001 Suzuki Swift models. Delphi applies OE-based engineering practices to its aftermarket steering and suspension portfolio, with material and dimensional checks aimed at maintaining proper part-to-vehicle compatibility. The rubber design helps restore the control arm’s pivot point performance while supporting stable suspension articulation. This part number, TD858W, is a direct service replacement for drivers addressing wear in the rear lower rearward bushing location on Suzuki Swift suspension systems.

This part cross-references Monroe Shocks & Struts (e.g., 172286) for the same application.

What This Part Helps Address

• Excessive play or looseness in the rear lower rearward control arm bushing
• Clunking or knocking noises from worn suspension pivot points
• Uneven suspension response caused by deteriorated rubber bushings
• Loss of alignment stability related to bushing wear
• Harshness or vibration transferred through the rear suspension

Installation Notes and Tips

Fits 1989-2001 Suzuki Swift, rear lower rearward. Confirm the press-fit bore dimensions and control arm condition before installation. Because this is a press-fit bushing, proper suspension service tools and correct alignment procedures are important after replacement. Verify the vehicle’s rear lower rearward position and compare the old bushing dimensions to TD858W before assembly.

Quality Assurance

Delphi tests OE-style steering and suspension parts under extreme temperature conditions below -40 degrees C and above 120 degrees C, and exposes them to 720 hours of salt spray for durability evaluation. TD858W is backed by Delphi’s OE-focused material and dimensional analysis for aftermarket fitment consistency.