Delphi TD925W Suspension Control Arm Bushing - Front

Delphi TD925W Front Control Arm Bushing

The Delphi TD925W is a front suspension control arm bushing built as a standard replacement for select applications. It is sized for precise OE-style fitment and is backed by Delphi’s aftermarket engineering approach, which draws on original equipment experience and dimensional analysis for better part-to-vehicle compatibility.

Compatible with 2010-2011 Saab 9-5 front applications with chassis control, this bushing is a direct-fit suspension service part for restoring front-end control arm support. The Delphi TD925W is finished in black and built to match the dimensional requirements of the original component.

Key Features

• Front suspension control arm bushing for OE-style replacement
• Standard replacement grade for service and repair work
• Black finish
• Measured dimensions: 1.52 in. length, 1.81 in. width, 1.85 in. height
• Inside diameter: 1.02 in. for proper fitment
• Engineered using Delphi OE dimensional and material analysis
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation

Detailed Description

Delphi TD925W suspension control arm bushing is designed for the front position on 2010-2011 Saab 9-5 models equipped with chassis control. Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, using dimensional and material analysis to support accurate replacement fit. This part cross-references OE number 13281782 for the same application. For buyers searching for a front control arm bushing for Saab 9-5 chassis control models, TD925W provides a direct replacement option with OE-style sizing and material specification.

Common Repair Symptoms

• Front suspension clunking or knocking over bumps
• Excessive play in the control arm mounting point
• Uneven tire wear caused by worn suspension bushings
• Loose or imprecise steering feel at the front end
• Vibration or harshness transmitted through the suspension

Installation Notes and Tips

Verify the vehicle is a 2010-2011 Saab 9-5 with chassis control before ordering. Confirm the front position and compare the original bushing dimensions to the listed measurements: 38.5 mm length, 46.0 mm width, 47.0 mm height, and 26.0 mm inside diameter. Suspension bushings are typically installed during control arm service or when replacing worn front suspension components, and proper alignment should be checked after installation.

Quality Assurance

Delphi uses OE-based testing and validation methods for this part, including exposure to extreme temperatures and extended salt spray testing. The TD925W is built to support consistent fit and durability expectations for front suspension service on the listed Saab 9-5 applications.