Delphi TD966W Suspension Control Arm Bushing - Rear Upper Inner

Delphi TD966W Rear Upper Inner Bushing

The Delphi TD966W is a suspension control arm bushing built for the rear upper inner position on select BMW X5 models. It uses rubber construction and a press-fit design to restore proper suspension location and help maintain consistent rear suspension geometry.

Key Features

• Rubber suspension control arm bushing for OE-style replacement
• Press-fit mounting type for the rear upper inner position
• Standard replacement grade for service and repair work
• Dimensions: 12.0 mm inside diameter, 47.5 mm outside diameter, 40.5 mm height
• Engineered using Delphi dimensional and material analysis for OE-to-aftermarket compatibility
• Tested for temperature extremes below -40 C and above 120 C, plus 720 hours of salt spray exposure

Detailed Description

Delphi TD966W is a suspension control arm bushing designed for BMW X5 rear upper inner applications from 2000-2016. As a rubber press-fit bushing, it is intended to replace worn suspension pivot points that can affect alignment stability, ride control, and rear-end response. This part cross-references Beck/Arnley 102-6086 and Dorman Premium CB14516PR for the same application. If you are servicing a BMW X5 and need a rear upper inner control arm bushing, the Delphi TD966W provides a direct-fit replacement option backed by Delphi OE-focused engineering.

What It Helps Address

• Rear suspension looseness or excess movement
• Clunking or knocking from worn control arm bushings
• Uneven tire wear related to suspension bushing wear
• Imprecise rear suspension response on BMW X5 models
• Alignment instability caused by deteriorated rubber bushings

Installation Notes and Tips

Fits 2000-2016 BMW X5, rear upper inner. This is a press-fit bushing, so proper removal and installation tools are recommended to avoid damaging the control arm or the new bushing. Verify the position, dimensions, and vehicle application before installation, especially when servicing a BMW X5 rear upper inner suspension location. The Delphi TD966W should be installed with the suspension at normal ride height when final tightening procedures apply to the control arm assembly.

Quality Assurance

Delphi applies OE-focused dimensional and material analysis to improve fitment consistency between original and aftermarket parts. The TD966W is also tested across extreme temperatures and salt spray exposure to support durability in demanding suspension environments.