Delphi TL2073 Steering Tie Rod End Assembly - Front Right

Front Right Steering Tie Rod End Assembly

Delphi TL2073 is a front right steering tie rod end assembly built for OE-style replacement on select BMW applications. It combines a steel tie rod, pre-greased construction, and a black dust boot to support precise steering response and consistent front-end alignment.

Key Features

• Part number: TL2073
• Front right steering tie rod end assembly
• Adjustable design for proper steering linkage setup
• Steel tie rod with painted finish
• Pre-greased and supplied with a black dust boot
• Washer and locking nut included
• Male threaded ends with clockwise (right) thread direction
• Standard replacement grade
• Rod diameter: 16.70 mm (0.650 in.)
• Length from stud center to end: 349.50 mm (13.750 in.)

Detailed Description

Delphi applies OE-focused engineering to its aftermarket steering portfolio, using dimensional and material analysis to help maintain proper fit and function. TL2073 is a bent-style steering tie rod end assembly with a chloroprene rubber dust boot, black painted finish, and threaded stud design. It is built for the front right position and is listed for BMW 230i xDrive, M240i xDrive, 430i Gran Coupe, 430i xDrive, 430i xDrive Gran Coupe, 440i Gran Coupe, 440i xDrive, 440i xDrive Gran Coupe, 330i GT xDrive, 330i xDrive, 340i GT xDrive, 320i xDrive, 328d xDrive, 340i xDrive, 228i xDrive, 328i GT xDrive, 328i xDrive, 335i GT xDrive, 428i xDrive, 428i xDrive Gran Coupe, 435i xDrive, 435i xDrive Gran Coupe, M235i xDrive, and 335i xDrive applications. This part cross-references MOOG Chassis Products ES800944A for the same application.

What This Part Helps Address

• Loose or imprecise steering feel at the front right wheel
• Uneven tire wear caused by worn steering linkage components
• Clunking or play in the steering system
• Alignment issues after tie rod end wear
• Front-end steering response loss on BMW xDrive models

Installation Notes and Tips

Install TL2073 at the front right steering position only. Verify thread direction, stud engagement, and overall length before alignment. Because this is an adjustable steering component, a professional wheel alignment is recommended after installation. Confirm vehicle-specific fitment for your BMW 230i xDrive, M240i xDrive, or other listed 3 Series and 4 Series applications before service.

Quality Assurance

Delphi subjects steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. The brand also uses dimensional and material analysis to support OE-level compatibility in the aftermarket. Part number TL2073 is engineered as a standard replacement steering tie rod end assembly for select BMW front right applications.