Delphi TL2078 Steering Tie Rod End Assembly - Front

Delphi TL2078 Front Steering Tie Rod End Assembly

Restore precise steering response with the Delphi TL2078 steering tie rod end assembly. Built as a standard replacement for the front steering system, it is pre-greased, adjustable, and supplied with a dust boot, washer, mounting hardware, and locking nut for a complete service-ready setup.

Key Features

• Part number: TL2078
• Front steering tie rod end assembly
• Standard replacement design
• Adjustable straight tie rod end
• Pre-greased for initial service
• Dust boot included
• Washer and mounting hardware included
• Aluminum tie rod construction
• Black painted finish
• Clockwise (right) thread direction on both ends

Detailed Description

Delphi applies OE-focused engineering to its aftermarket steering portfolio, and the TL2078 reflects that approach with dimensional and material analysis aimed at proper OE-to-aftermarket match. The assembly uses an aluminum tie rod body with a chloroprene rubber dust boot, a threaded stud design, and a 13.750 in. (349.50 mm) stud-center-to-end length. It is built for front steering service and is listed as a direct replacement style component for Tesla 3 and Tesla Y applications. This part cross-references Mevotech Supreme MS95668 for the same application.

Vehicle Fitment

• Fits 2017-2023 Tesla 3, front
• Fits 2020-2023 Tesla Y, front

Common Problems This Part Can Address

• Loose or vague steering feel
• Excessive play in the front steering linkage
• Uneven tire wear caused by worn tie rod components
• Clunking or knocking from the front suspension and steering area
• Difficulty maintaining proper front-end alignment

Installation Notes and Tips

Confirm thread direction, rod length, and front position before installation. After replacement, perform a professional wheel alignment to set toe and verify steering wheel center. Inspect adjacent steering and suspension components for wear so the new tie rod end is not installed into a worn system.

Quality Assurance

Delphi subjects steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. The TL2078 is backed by Delphi OE-focused manufacturing standards for consistent fit and performance.