Delphi TL359 Suspension Stabilizer Bar Link Kit - Front

Delphi TL359 Front Stabilizer Bar Link Kit

Delphi TL359 is a front suspension stabilizer bar link kit built for OE-style replacement performance. It uses ball joint ends, a pre-greased design, and a dust boot to help maintain consistent sway bar connection on the vehicle’s front suspension.

Fits 1990-1992 Audi 80, front; Fits 1990-1991 Audi 90, front; Fits 1990 Audi 90 Quattro, front; Fits 1990-1991 Audi Coupe Quattro, front; Fits 1991-1992 Audi 80 Quattro, front; Fits 1991-1995 Audi 90 Quattro, front; Fits 1993-1995 Audi 90, front; Fits 1995-1998 Audi Cabriolet, front.

• Front suspension stabilizer bar link kit for OE replacement service
• Ball joint ends on both sides for sway bar connection
• Pre-greased design for ready-to-install service
• Dust boot included to help protect the joint area
• Black rubber bushing material with POM bearing material
• M10 bolt thread size with locking nuts included
• Standard replacement grade for front suspension repair

Detailed Product Overview

Delphi TL359 is a front sway bar link designed for Audi applications that require a direct-fit stabilizer bar connection. It is listed for the Audi 80, Audi 90, Audi 90 Quattro, Audi 80 Quattro, Audi Coupe Quattro, and Audi Cabriolet across the model years shown, including select VIN-specific 90 Quattro and 80 Quattro applications. This part cross-references Mevotech Supreme MK90112 for the same application.

Delphi applies OE-focused dimensional and material analysis to support fitment consistency between the original part and the aftermarket replacement. The component is tested for extreme temperature exposure and salt spray resistance, which supports use in demanding undercar conditions. Delphi TL359 is a practical choice when replacing a worn front stabilizer link on Audi suspension systems.

Common Problems This Part Can Address

• Front-end clunking or knocking over bumps
• Excessive sway bar movement from worn link joints
• Loose or unstable steering feel caused by degraded stabilizer link components
• Noise from damaged dust boots or worn ball joint ends
• Uneven suspension response at the front axle

Installation Notes and Tips

Confirm front-position fitment and verify the vehicle’s year, model, and VIN notes before ordering. This part uses M10 thread hardware at the link ends and includes locking nuts; bolts, washers, and grease fittings are not included. Because it is a pre-greased, non-greaseable design, no routine greasing is required after installation.

For best results, inspect the sway bar, mounting points, and adjacent suspension components for wear before installing the new link. Delphi TL359 is a direct replacement for front stabilizer bar service on the listed Audi applications.

Quality Assurance

Delphi builds this suspension link using OE-oriented testing and material validation. The part is evaluated across extreme temperature ranges and extended salt-spray exposure to support durability in real-world driving conditions.