Delphi TL418 Steering Tie Rod End Assembly - Left

Delphi TL418 Steering Tie Rod End Assembly

The Delphi TL418 steering tie rod end assembly is a standard replacement part for the left side of select Mercedes-Benz 190E models. Built with a steel tie rod, rubber dust boot, and cataphoresis finish, it is engineered for consistent steering response and corrosion resistance in demanding road conditions.

Key Features

• Fits 1984-1993 Mercedes-Benz 190E, left
• Standard replacement steering tie rod end assembly
• Steel tie rod construction with black finish
• Cataphoresis coating for added corrosion protection
• Rubber dust boot helps protect internal steering components
• Mounting hardware included
• No grease fitting and non-greaseable design

Detailed Description

Delphi TL418 is built for Mercedes-Benz 190E steering service where precise linkage movement and durable construction matter. Delphi applies OE-level dimensional and material analysis to help ensure proper fit and consistent performance, and each part is tested across extreme temperature ranges and salt-spray exposure to verify durability. If you are replacing a worn left steering tie rod end on a 1984-1993 Mercedes-Benz 190E, this Delphi TL418 assembly provides a direct-fit service part for the application.

This part cross-references Mercedes-Benz OE numbers 201 330 1503 and T3018 for the same application.

Common Problems This Part Can Help Address

• Loose or vague steering feel on the left side
• Clunking or knocking from worn steering linkage
• Uneven tire wear caused by steering play
• Steering wheel wander or poor directional stability
• Visible wear in the tie rod end dust boot or joint

Installation Notes and Tips

Install on the left side only and verify alignment after replacement. Inspect adjacent steering components, including the inner tie rod and related suspension joints, before finalizing the repair. Because this assembly is non-greaseable, routine service focuses on proper installation and periodic inspection rather than lubrication.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its steering portfolio, including temperature and corrosion testing, to support dependable aftermarket replacement performance. Part number TL418 is built to match the intended Mercedes-Benz 190E application with attention to fit, materials, and durability.