Delphi TL428 Steering Tie Rod End Assembly - Right

OE-Style Steering Tie Rod End for Volkswagen

Delphi TL428 is a right-side steering tie rod end assembly built for Volkswagen Corrado, Golf, and Jetta applications with the specified TRW design. It combines a steel tie rod body, cataphoresis finish, and a chloroprene rubber dust boot to support precise steering response and long-term corrosion resistance.

Delphi applies OE-level dimensional and material analysis to help ensure proper fit and consistent steering geometry for the vehicle platform. This Delphi TL428 tie rod end is a direct replacement choice for right-side steering service on select Volkswagen models.

Key Features

• Right-side steering tie rod end assembly
• Straight, adjustable design
• Steel tie rod construction with black cataphoresis finish
• Dust boot included; grease fitting not included
• Male end connections with clockwise thread direction
• End 1 thread diameter: 12.0 mm; End 2 thread diameter: 14.0 mm
• Mounting hardware included
• Standard replacement grade

Detailed Description

The Delphi TL428 steering tie rod end assembly is engineered for right-side use on 1985-1992 Volkswagen Golf, 1985-1992 Volkswagen Jetta, and 1990-1995 Volkswagen Corrado applications listed with the TRW design and 374 mm length note where applicable. It is built with a steel tie rod, adjustable straight layout, and a chloroprene rubber dust boot to help protect the joint from road contamination.

Delphi validates steering components through temperature and corrosion exposure testing, including extreme hot and cold conditions and extended salt spray exposure. This part cross-references Beck/Arnley 101-3998 for the same application. Use Delphi TL428 when replacing a worn right steering tie rod end on Volkswagen Corrado, Golf, or Jetta models that match the listed fitment.

Common Problems This Part Can Address

• Excessive steering play or looseness at the right front steering linkage
• Uneven tire wear caused by worn tie rod end joints
• Clunking or knocking from the steering system during turns or bumps
• Steering wheel wander or reduced directional stability
• Corrosion-related wear on the steering linkage end

Installation Notes and Tips

Verify the vehicle’s right-side application, TRW design, and listed length before installation. After replacement, have the front-end alignment checked to restore correct toe settings and steering wheel position. Inspect the adjacent steering components, including the inner tie rod and related boots, for wear before completing the repair.

Quality Assurance

Delphi uses OE-focused engineering and material analysis for aftermarket steering parts, with testing that includes extreme temperature cycling and salt spray exposure. The TL428 is built to meet standard replacement expectations for fit and durability on the specified Volkswagen applications.