Delphi TL512 Steering Tie Rod Assembly

Delphi TL512 Steering Tie Rod Assembly

Delphi TL512 is a straight steering tie rod assembly built with carbon steel construction and a black finish for OE-style steering service. It is adjustable and uses male-to-female end connections, making it a direct replacement choice for select Volkswagen steering applications.

Key Features

• Carbon steel construction for strength in steering service
• Straight tie rod design with adjustable length
• Male end and female end configuration
• Black finish
• Standard replacement grade
• No grease fitting included

Application Details

Compatible with select Volkswagen steering systems, including Fits 1985-1993 Volkswagen Cabriolet, N/A and Fits 1980-1984 Volkswagen Jetta, N/A. The Delphi TL512 tie rod assembly is also a fitment match for 1980-1993 Volkswagen Cabriolet and Jetta applications covered by the listed vehicle range. This part cross-references Beck/Arnley 101-3475 for the same application.

What It Helps Address

• Loose or worn steering linkage components
• Uneven steering response caused by tie rod wear
• Front-end alignment issues related to steering play
• Noise or vibration from deteriorated steering hardware
• Restoring proper steering geometry on Volkswagen Cabriolet and Jetta models

Installation Notes and Tips

Verify thread direction, end configuration, and vehicle application before installation. Because this tie rod assembly is adjustable, a professional wheel alignment is required after replacement. Confirm the steering system condition and inspect related components such as inner tie rods, boots, and alignment hardware during service.

Quality Assurance

Delphi applies OE-level dimensional and material analysis to its aftermarket steering portfolio. This part is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability in demanding conditions.