Delphi TL524 Steering Tie Rod End Assembly - Right

Delphi TL524 Right Steering Tie Rod End Assembly

Delphi TL524 is a standard replacement steering tie rod end assembly for the right side of the steering linkage. It is built with a steel tie rod, black cataphoresis finish, and a chloroprene rubber dust boot to help protect the joint from road contamination.

Fits 1998 Volkswagen Beetle, right. This Delphi tie rod end assembly is engineered with OE-focused dimensional and material analysis for proper alignment with the original steering geometry on the 1998 Volkswagen Beetle right-side application.

Key Features

• Part number: TL524
• Right-side steering tie rod end assembly
• Straight design with adjustable construction
• Male-to-male thread configuration
• Steel tie rod material with cataphoresis finish
• Dust boot included for joint protection
• Mounting hardware included
• Grease-free, non-greaseable design
• Thread specs: 12.0 mm x 1.5 on one end and 16.0 mm x 1.5 on the other

Detailed Description

Delphi TL524 is a steering tie rod end assembly made for the right side and built as a standard replacement part for steering service. Delphi applies OE-based testing and dimensional analysis to help ensure the part matches the original fit and material expectations for the application. The assembly is tested for extreme temperature exposure and salt spray resistance to support durability in demanding road conditions. This part cross-references MOOG Chassis Products ES3710A for the same application.

For Volkswagen Beetle steering repair work, TL524 provides the correct right-side configuration for the 1998 Volkswagen Beetle, right. If you are replacing worn steering linkage components on a 1998 Volkswagen Beetle right-side setup, Delphi TL524 offers the specified thread direction, adjustable length, and protective boot design needed for a direct-service replacement.

What This Part Helps Address

• Loose or wandering steering feel
• Clunking or play from a worn tie rod end
• Uneven front-end alignment caused by steering linkage wear
• Damaged dust boot exposure to dirt and moisture
• Steering response issues on the right side of the linkage

Installation Notes

Verify the vehicle is a 1998 Volkswagen Beetle with right-side fitment before installation. Match the thread diameter, pitch, and clockwise thread direction to the removed part, and inspect the steering linkage, alignment settings, and adjacent components for wear before returning the vehicle to service. A professional wheel alignment is recommended after steering component replacement.

Quality Assurance

Delphi uses OE-focused engineering, dimensional checks, and material analysis to support fit and performance consistency. The part is also subjected to temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing for durability validation.