Denso 234-9060 Air / Fuel Ratio Sensor - Upstream

Denso OE Style Air/Fuel Ratio Sensor

Denso 234-9060 is an OE Style heated air/fuel ratio sensor built for precise replacement and a first-time fit. It is made for specific applications and matches the factory-style connector and wiring layout used on select Honda Fit models.

Key Features

• Heated air/fuel ratio sensor for faster operating response
• Specific fit for direct replacement on the listed application
• 4-wire design with male connector
• Wiring harness length: 10.63
• Thread diameter: 0.711
• OE Style construction for factory-style fit and function

Application Details

Fits 2007-2008 Honda Fit, upstream. This Denso 234-9060 sensor is built to match the original equipment layout for the upstream location on 2007-2008 Honda Fit models. The OE Style line focuses on exact replacement dimensions and connector compatibility, helping maintain proper air-fuel feedback in the exhaust stream.

This part cross-references Bosch 15260 and NTK 25680 for the same application.

What It Helps Address

• Check engine light related to air/fuel ratio sensor performance
• Incorrect upstream sensor readings
• Rough idle caused by inaccurate mixture feedback
• Fuel trim issues tied to sensor response problems
• Emissions test failures related to sensor malfunction

Installation Notes

Verify the upstream sensor location, connector style, wire count, and thread size before installation. The specific-fit design is intended to match the factory mounting point on the listed Honda Fit applications, which helps reduce installation errors and connector mismatch. Always confirm the part number 234-9060 against the vehicle’s original sensor before replacement.

Quality Assurance

Denso manufactures and tests these sensors to OE standards, with precision-built components aimed at accurate replacement fit and consistent performance. The OE Style product line is focused on factory-style replacement parts for vehicles that require exact dimensions and dependable sensor operation.