Denso 950-0190 Fuel Pump and Strainer Set

Denso 950-0190 Fuel Pump and Strainer Set

Denso 950-0190 is an electric in-tank fuel pump and strainer set for select Suzuki, Chevrolet, and Mitsubishi applications. It is built for vehicles that need a direct replacement fuel pump assembly with the correct strainer dimensions and inlet sizing for proper fuel delivery.

Key Features

• Electrical fuel pump for in-tank mounting
• Fuel pump and strainer set for fuel delivery service
• Strainer length: 83.0
• Strainer width: 55.00
• Strainer fitting diameter: 0.43
• Direct-fit application coverage for select Grand Vitara, Tracker, Vitara, Esteem, Metro, Sidekick, and Precis models

Product Details

This Denso fuel pump and strainer set is specified for in-tank electric fuel system service where the pump and pickup strainer must match the vehicle’s original layout. The Denso 950-0190 is listed for 1999-2005 Suzuki Grand Vitara, 1999-2004 Chevrolet Tracker, 1999-2004 Suzuki Vitara, 1999-2002 Suzuki Esteem, 1998-2001 Chevrolet Metro, 1997-1998 Suzuki Sidekick, and 1990-1994 Mitsubishi Precis. This part cross-references Carter (e.g., P72236, P72237) for the same application.

Common Uses

• Restoring fuel pressure after a failing electric in-tank pump
• Addressing hard-start or no-start conditions tied to fuel delivery
• Replacing a clogged or damaged fuel strainer
• Correcting fuel starvation caused by restricted pickup flow
• Servicing a noisy or weak fuel pump on select Suzuki, Chevrolet, and Mitsubishi vehicles

Installation Notes

Verify the vehicle’s year, make, model, and fuel system configuration before installation. Confirm the in-tank pump placement and strainer dimensions match the original unit, especially on applications such as the 1990-1994 Mitsubishi Precis with an 11mm fuel pump inlet note. Clean the tank and inspect the fuel lines, electrical connector, and sealing surfaces during replacement.

Quality Assurance

Denso is an established OE supplier in automotive fuel system components, and this part is built to meet the fitment and dimensional requirements listed for the confirmed applications.