Dorman 242-6113 Bumper End Cap - Front Left

Dorman 242-6113 Bumper End Cap

Restore the corner of your bumper with this direct replacement bumper end cap from Dorman. Part number 242-6113 is shaped to match the original equipment contour for a clean, factory-style repair on compatible applications.

• Direct replacement bumper end cap for body hardware repair
• Matches the original shape and contour for a seamless appearance
• Plastic construction with a black finish
• Specific fit design for accurate placement
• Attaches with screws and includes mounting hardware
• Dimensions: 30 length, 17 width, 19 depth
• Hollow composition for OE-style construction

OE-Style Replacement Details

This bumper end cap is built for drivers replacing a damaged corner trim piece on a vehicle bumper. The Dorman 242-6113 is a specific-fit part that follows the original equipment profile, helping maintain the factory look after impact damage, wear, or missing trim. It cross-references Monroe Shocks & Struts (e.g., 82741354) for the same application. For shoppers searching for a bumper end cap replacement for Dorman 242-6113, or a black plastic bumper corner cap for body repair, this part is built around the original contour rather than a universal shape.

Compatible With select vehicle applications, including make/model searches such as bumper end cap replacement for Honda Civic, Toyota Corolla, and Ford F-150 style body repair queries when matched to the listed application data. Use the vehicle-specific fitment details before ordering to confirm the correct corner bumper piece for your exact configuration.

What It Helps Repair

• Cracked or broken bumper corner trim
• Missing end cap after minor collision damage
• Worn exterior appearance at the bumper edge
• Loose or poorly retained bumper corner hardware
• Mismatch caused by a previous non-OE-style repair

Installation Notes

Install using the screw attachment points and verify alignment against the bumper contour before tightening. Because this is a specific-fit bumper end cap, compare the part shape, dimensions, and mounting style to the original piece before installation. Confirm the vehicle application and position details for the exact bumper corner location.

Quality Assurance

Dorman supplies direct replacement body hardware engineered to match original equipment form and fit. Part number 242-6113 is built as a replacement bumper end cap for repair-focused applications where contour, mounting style, and finish need to align with the factory part.