Dorman 520-033 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Dorman 520-033 Front Left Lower Control Arm

Dorman 520-033 is a direct replacement suspension control arm and ball joint assembly for specific Honda Fit applications. It is built for the front left lower position on 2006-2008 Honda Fit models and is engineered to restore stable steering response, consistent ride quality, and predictable suspension movement.

Key Features

• Direct replacement for the original equipment control arm assembly
• Fits 2006-2008 Honda Fit, front left lower
• Stamped steel control arm construction with black finish
• Pre-greased ball joint included and installed
• Press-in ball joint mounting with threaded stud
• Bushings included with steel and rubber construction
• Mounting hardware included
• Standard replacement grade for OE-style service

Detailed Description

This Dorman suspension control arm and ball joint assembly is built for the front left lower suspension position on the Honda Fit. The stamped steel arm, press-in ball joint design, and included bushings are selected to match the original equipment layout on the specified applications. Dorman part number 520-033 is intended to support proper wheel control and suspension geometry on 2006, 2007, and 2008 Honda Fit models.

The assembly is pre-greased and includes the ball joint already installed, which helps simplify service work during replacement. It also includes mounting hardware and uses a threaded ball joint stud with a 12 mm thread diameter. This part cross-references Honda 51360SAET01 and 1509011 for the same application.

What This Part Helps Address

• Clunking or looseness from a worn lower control arm assembly
• Uneven steering feel caused by suspension wear
• Directional instability at the front left lower suspension corner
• Excess movement from deteriorated bushings or ball joint wear
• Restoring OE-style suspension geometry on a Honda Fit

Installation Notes and Tips

Verify vehicle application before installation: Fits 2006-2008 Honda Fit, front left lower. Inspect adjacent suspension components, alignment settings, and fasteners during service. Because the ball joint is press-in and the assembly includes an installed ball joint, proper suspension tools and alignment procedures are recommended after replacement. Dorman 520-033 is a direct-fit service part for the listed application.

Quality Assurance

Dorman uses an industry-focused evaluation process for this control arm and ball joint assembly to help deliver consistent ride behavior, directional stability, and predictable suspension dynamics. The part is built as a standard replacement component for the specified Honda Fit applications.