Dorman 522-219 Suspension Control Arm - Rear Left Upper or Rear Right Upper

Dorman 522-219 Rear Upper Control Arm

Dorman 522-219 is a steel suspension control arm built for specific Mitsubishi Outlander rear upper applications. It is precision-engineered and tested as a direct replacement for the original equipment part on 2003-2006 Mitsubishi Outlander models.

Key Features

• Steel stamped construction with a coated black finish for corrosion resistance
• Includes a rubber bushing with black bushing color
• Welded ball joint mounting type with threaded ball joint stud type
• Overall length: 262.5 mm
• Press-in end 2 type and bushing linkage end type
• No grease fitting, no ball joint installed, and no mounting hardware included
• Direct replacement for rear left upper and rear right upper positions

Detailed Description

This Dorman 522-219 suspension control arm is built for the rear upper suspension on the Mitsubishi Outlander, covering both rear left upper and rear right upper positions for 2003-2006 vehicles. The stamped steel design, coated finish, and rubber bushing help restore the original suspension geometry and connection point when the factory arm is worn, bent, or corroded. This part cross-references MOOG Chassis Products RK641471 for the same application.

For buyers searching for a rear upper control arm for Mitsubishi Outlander 2003-2006, Dorman 522-219 provides an OE-style replacement option with the correct mounting style and dimensions for the listed application. It is also referenced under Beck/Arnley 102-7607 for the same vehicle fitment.

What It Helps Fix

• Excessive rear suspension play from worn control arm bushings
• Clunking or knocking noises from the rear suspension
• Uneven tire wear caused by suspension alignment issues
• Loose or unstable rear-end handling on the Mitsubishi Outlander
• Corrosion or structural damage to the original upper control arm

Installation Notes and Tips

Verify rear left upper or rear right upper placement before installation on your Mitsubishi Outlander. Because mounting hardware is not included, reuse or replace fasteners as needed during service. After installation, a professional wheel alignment is recommended to confirm suspension geometry and tire wear settings.

Quality Assurance

Dorman manufactures this control arm as a tested replacement part for specific OE applications. The steel construction, welded ball joint mounting point, and coated finish are selected to match the demands of suspension service on 2003-2006 Mitsubishi Outlander models.