Dorman 522-928 Suspension Control Arm and Ball Joint Assembly - Front Right Upper Rearward

Dorman 522-928 Front Right Upper Rearward Control Arm

Dorman 522-928 is a direct replacement suspension control arm and ball joint assembly for specific Audi applications. It is built for the front right upper rearward position and uses an aluminum control arm with a pre-installed ball joint and bushings for OE-style fit and function.

• Direct replacement for the original equipment control arm and ball joint assembly
• Fits the front right upper rearward suspension position
• Aluminum control arm with rubber bushings
• Ball joint is installed and press-in mounted with a pinch-style stud
• Pre-greased for initial service readiness
• Mounting hardware included
• Regular grade, light suspension application

OE-Style Suspension Replacement

This Dorman suspension control arm assembly is engineered for specific Audi A6, Audi A6 Quattro, and Audi S6 models. It is intended to restore proper suspension geometry, directional stability, and predictable handling when replacing a worn front right upper rearward control arm. The aluminum casting/forged construction, rubber bushings, and installed ball joint support a factory-style repair on 2008-2011 Audi A6 and A6 Quattro models, plus 2010-2011 Audi S6 applications with the listed suspension notes. Part number 522-928 is also referenced for OE-style replacement needs in these applications.

This part cross-references 4E0407510G and 101-5967 for the same application.

What This Part Helps Address

• Clunking or knocking from the front suspension
• Excessive play in the upper control arm area
• Uneven tire wear caused by worn suspension joints
• Steering wander or reduced directional stability
• Loose or inconsistent front-end handling

Installation Notes

Fits 2008 Audi A6, front right upper rearward; Fits 2008 Audi A6 Quattro, front right upper rearward; Fits 2009-2011 Audi A6, front right upper rearward; Fits 2009-2011 Audi A6 Quattro, front right upper rearward; Fits 2010-2011 Audi S6, front right upper rearward. Verify VIN break and suspension notes before installation, including the 2008 from VIN 4F-8-018 001 note and the 2010-2011 S6 without Sport Suspension note. Because the ball joint is installed and the assembly is pre-greased, installation focuses on correct alignment of the mounting points and torqueing fasteners to vehicle specifications.

Quality Assurance

Dorman uses an industry-leading evaluation process for this control arm and ball joint assembly to support smooth ride quality, directional stability, and predictable suspension response. The part is built as a direct replacement for the original equipment design on the listed Audi A6, Audi A6 Quattro, and Audi S6 applications.