Dorman 524-184 Suspension Control Arm - Rear Right Upper

Rear Right Upper Suspension Control Arm

Dorman 524-184 is a steel suspension control arm built for direct replacement on specific Ford, Mercury, and related applications. It is precision-engineered and tested to match the original equipment function on the listed vehicles, including the rear right upper position on the Ford Taurus, Taurus X, Five Hundred, Freestyle, Mercury Sable, and Mercury Montego.

This Dorman 524-184 control arm uses a casting/forged construction with a coated black finish for corrosion resistance. It features a welded ball joint mounting type and threaded ball joint stud type, while the ball joint itself is not included. The arm also uses rubber and steel bushing materials, with a press-in end 2 design and no grease fitting, bushings, or mounting hardware included.

• Steel suspension control arm with casting/forged construction
• Black coated finish for added surface protection
• Rear right upper position for listed Ford and Mercury vehicles
• Welded ball joint mounting type with threaded stud interface
• Rubber and steel bushing design with press-in end 2 type
• Direct replacement part number 524-184 for OE-style service

Detailed Fitment and Application

Use Dorman 524-184 when replacing a worn rear right upper suspension control arm on 2008-2009 Ford Taurus, 2008-2009 Ford Taurus X, 2008-2009 Mercury Sable, 2005-2007 Ford Five Hundred, 2005-2007 Ford Freestyle, and 2005-2007 Mercury Montego. This part cross-references 6F9Z5A804C for the same application. The 524-184 is built to restore the original suspension arm geometry on these vehicles and support proper rear suspension operation.

What This Part Helps Correct

• Rear suspension looseness or instability
• Clunking or knocking from the rear suspension area
• Uneven tire wear caused by worn control arm bushings
• Excessive rear wheel movement from a fatigued arm assembly
• Alignment issues related to worn rear upper control arm components

Installation Notes and Tips

Install this control arm in the rear right upper position only on the listed applications. Because the ball joint, bushings, and mounting hardware are not included, inspect the related suspension components before installation and replace any worn mating parts as needed. Verify vehicle year, make, model, and rear suspension configuration before ordering or installation.

Quality Assurance

Dorman manufactures this suspension control arm as a tested replacement part for specific OE applications. The 524-184 is engineered to meet the fit and function requirements of the original component on the listed Ford and Mercury vehicles.