Dorman 524-954 Suspension Control Arm and Ball Joint Assembly - Rear Right Upper

Dorman 524-954 Rear Right Upper Control Arm

Dorman 524-954 is a direct replacement suspension control arm and ball joint assembly for specific vehicle applications. It is built for the rear right upper position on 2004-2006 Suzuki Verona models and is engineered to restore smooth ride quality, directional stability, and predictable handling.

• Direct replacement for the original equipment control arm and ball joint assembly
• Fits 2004-2006 Suzuki Verona, rear right upper
• Stamped steel control arm with black finish
• Ball joint is installed and pre-greased
• Rubber bushings included
• Press-in, machined ball joint mounting with threaded stud
• Mounting hardware included

Built for OE-Style Suspension Performance

This Dorman suspension control arm assembly is made for drivers replacing worn rear suspension components on the Suzuki Verona. The stamped steel construction, installed ball joint, and rubber bushings help return the suspension to proper geometry and support consistent road feel. Dorman 524-954 is a practical OE-style replacement for the rear right upper position on 2004, 2005, and 2006 Suzuki Verona vehicles.

This part cross-references Mevotech Supreme CMS50184 for the same application.

Common Problems This Part Can Address

• Clunking or knocking from the rear suspension
• Excessive play from a worn ball joint or bushing
• Uneven tire wear caused by suspension looseness
• Reduced directional stability during braking or cornering
• Suspension noise from deteriorated control arm components

Installation Notes and Tips

Verify the rear right upper position and confirm vehicle fitment before installation. Because the ball joint is press-in and already installed, replacement focuses on swapping the assembly rather than rebuilding the arm. Inspect adjacent suspension components, alignment settings, and mounting points during service to ensure proper operation after installation.

Quality Assurance

Dorman uses an evaluation process for this control arm and ball joint assembly to help support consistent ride quality and suspension behavior. The part is built as a direct replacement for specific OE applications and is intended to meet the needs of routine suspension repair on the Suzuki Verona.