Dorman 526-948 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Dorman 526-948 Front Right Lower Control Arm

Dorman 526-948 is a direct replacement suspension control arm and ball joint assembly for specific Audi and Volkswagen applications. It is built for the front right lower position and is engineered to restore smooth ride quality, directional stability, and predictable steering response.

With a stamped steel arm, pre-greased ball joint, and included bushings, this assembly is a practical OE-style solution for worn front suspension components on the Audi A3, Audi A3 Quattro, Volkswagen Jetta, Volkswagen GTI, and related models.

Key Features

• Direct replacement for the original front right lower control arm assembly
• Stamped steel control arm with black finish
• Ball joint is installed and pre-greased
• Rubber bushings included for suspension mounting points
• Bolt-in ball joint mounting with threaded stud design
• Mounting hardware included
• Regular grade, light suspension application
• Compatible with vehicles using welded sheet metal arms

Detailed Description

This Dorman suspension control arm and ball joint assembly is designed for specific front right lower applications on 2004-2013 Audi A3 and A3 Quattro, plus 2005-2011 Volkswagen Jetta, 2006-2011 Volkswagen GTI, 2010-2011 Volkswagen Eos, 2010 Volkswagen GLI, 2005-2010 Volkswagen Bora, and 2011 Volkswagen Golf SportWagen. It is built as an OE-style replacement for vehicles equipped with welded sheet metal arms, helping maintain proper suspension geometry and consistent handling.

The assembly uses a stamped steel arm with rubber bushings and a bolt-in, threaded-stud ball joint that is already installed. Pre-greasing and included mounting hardware simplify service, while the direct-fit design supports accurate replacement of a worn or damaged front suspension arm. This part cross-references MOOG Chassis Products RK622868 for the same application.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play in the control arm or ball joint
• Uneven tire wear caused by worn suspension geometry
• Steering wander or reduced directional stability
• Vibration or looseness felt through the front end

Installation Notes and Tips

Verify the vehicle uses welded sheet metal arms before ordering. This assembly is for the front right lower position only and is not adjustable. Because the ball joint is already installed, inspect the surrounding suspension components, alignment angles, and fasteners during replacement. A professional wheel alignment is recommended after installation to confirm proper suspension geometry.

Quality Assurance

Dorman uses an industry-leading evaluation process for this control arm and ball joint assembly to help deliver consistent ride quality, directional stability, and predictable dynamics. The part number is 526-948.