Dorman 533-476 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Dorman 533-476 Stabilizer Bar Bushing Kit

Dorman 533-476 is a front-to-frame suspension stabilizer bar bushing kit for specific Chevrolet, Pontiac, and Oldsmobile applications. It is precision-engineered and tested as a standard replacement for the original equipment bushing on the listed vehicles.

Key Features

• Rubber construction for suspension bar support and isolation
• Black finish
• Specific fit for listed applications
• Inside diameter: 19 mm
• Outside diameter: 1.69 in.
• Assembled length: 1.96 in.
• Bracket included: No
• Mounting hardware included: No
• Grease fitting included: No
• Grade type: Standard replacement

Detailed Description

This Dorman stabilizer bar bushing kit is built for front-to-frame mounting locations and is sized for a 20 mm diameter bar on the covered vehicles. It is a direct-fit suspension bushing solution for the Chevrolet Cavalier, Chevrolet Classic, Chevrolet Malibu, Pontiac Grand Am, Pontiac Sunfire, Oldsmobile Alero, and Oldsmobile Cutlass applications listed below. Part number 533-476 is a practical OE-style replacement when the original sway bar bushings are worn, cracked, or no longer holding the stabilizer bar securely.

This part cross-references MOOG Chassis Products K6650 for the same application.

Vehicle Fitment

• Fits 1995-2005 Chevrolet Cavalier, Front To Frame, 20 mm Diameter Bar
• Fits 2004-2005 Chevrolet Classic, Front To Frame, 20 mm Diameter Bar
• Fits 1997-2003 Chevrolet Malibu, Front To Frame, 20 mm Diameter Bar
• Fits 1999-2005 Pontiac Grand Am, Front To Frame, 20 mm Diameter Bar
• Fits 1995-2005 Pontiac Sunfire, Front To Frame, 20 mm Diameter Bar
• Fits 1999-2004 Oldsmobile Alero, Front To Frame, 20 mm Diameter Bar
• Fits 1997-1999 Oldsmobile Cutlass, Front To Frame, 20 mm Diameter Bar

What It Helps Fix

• Clunking or knocking from the front suspension
• Excessive sway bar movement at the frame mount
• Worn, split, or hardened stabilizer bar bushings
• Loose-feeling front-end handling on the listed Chevrolet, Pontiac, and Oldsmobile models
• Noise caused by deteriorated rubber suspension bushings

Installation Notes and Tips

Confirm the stabilizer bar diameter and front-to-frame mounting style before installation. Inspect the bar surface and surrounding brackets for wear or corrosion, and replace damaged components as needed. Because mounting hardware is not included, reuse or source the required fasteners separately if your vehicle setup calls for them. Verify fitment by year, make, model, and bar size before ordering Dorman 533-476.

Quality Assurance

Dorman designs this bushing kit as a standard replacement part and subjects it to engineering review and testing for the listed applications. The rubber construction and vehicle-specific sizing support consistent suspension service on compatible Chevrolet, Pontiac, and Oldsmobile platforms.