Dorman 533-589 Suspension Stabilizer Bar Bushing Kit - Rear To Frame

Dorman 533-589 Rear Stabilizer Bar Bushing Kit

Dorman 533-589 is a suspension stabilizer bar bushing kit for specific Ford, Mercury, and Lincoln applications. It is precision-engineered and tested as a standard replacement for the original equipment bushing on the rear-to-frame stabilizer bar mount.

Key Features

• Rubber and elastomer construction for suspension service
• Inside diameter: 40.4 mm
• Outside diameter: 43.9 mm
• Width: 2.53 in.
• Assembled length: 2.36 in.
• No grease fitting included
• No bracket included
• Standard replacement grade

Application Details

This Dorman 533-589 stabilizer bar bushing kit is built for rear-to-frame mounting locations on vehicles with a 26 mm diameter bar. It fits 1986-1999 Ford Taurus, 1994-1999 Ford Sable, 1986-1999 Mercury Sable, and 1988-1994 Lincoln Continental. This part cross-references MOOG Chassis Products K8761 for the same application.

What It Helps Address

• Clunking or rattling from worn rear sway bar bushings
• Excessive play at the stabilizer bar mounting point
• Degraded rubber that can affect rear suspension control
• Noise caused by loose or compressed bushing material

Installation Notes

Confirm the vehicle uses a rear-to-frame stabilizer bar with a 26 mm diameter bar before ordering. Match the bushing dimensions to the original mount and inspect the stabilizer bar and brackets for wear or corrosion during service. Because no bracket is included, reuse the existing mounting hardware if it is in serviceable condition.

Quality Assurance

Dorman tests this replacement bushing kit for fit and function against the original equipment design. It is intended as a standard replacement part for the listed Ford Taurus, Ford Sable, Mercury Sable, and Lincoln Continental applications.