Dorman 540-284 Suspension Stabilizer Bar Bushing Kit - Rear

Dorman 540-284 Rear Stabilizer Bar Bushing Kit

Dorman 540-284 is a rear suspension stabilizer bar bushing kit for select Acura applications. It is precision-engineered and tested as a standard replacement for the original equipment bushing on specific vehicles, helping restore proper sway bar support and suspension control.

• Rubber bushing construction for suspension stabilizer bar service
• Standard replacement grade for OE-style fit and function
• Inside diameter: 16.6
• Assembled length: 35 mm
• Outside diameter / width: 34.3
• No grease fitting included
• No bracket included

Vehicle Fitment

Compatible with rear suspension applications on 2004-2006 Acura TL and 1999-2001 Acura RL. If you are searching for a rear stabilizer bar bushing kit for Acura TL or Acura RL service, Dorman 540-284 is the direct-fit replacement to review.

Detailed Description

This stabilizer bar bushing kit is built from rubber and sized for the specified rear sway bar application. Dorman 540-284 is intended to replace worn original bushings that can allow excess movement at the stabilizer bar, affecting suspension response and noise levels. It cross-references MOOG Chassis Products K200733 and Delphi TD4235W for the same application.

What It Helps Address

• Clunking or rattling from the rear suspension
• Excess sway bar movement caused by worn bushings
• Loose-feeling rear suspension response
• Noise from deteriorated rubber stabilizer bar bushings
• OE bushing wear on Acura TL and Acura RL rear applications

Installation Notes

Verify the stabilizer bar diameter and vehicle application before installation. This part is a bushing-only replacement and does not include a bracket or grease fitting. For best results, inspect the sway bar, mounting points, and surrounding suspension components for wear before reassembly.

Quality Assurance

Dorman engineers and tests this part as a standard replacement for the original equipment on the listed vehicles. The 540-284 part number is supported by OE-style fitment validation for the specified Acura rear suspension applications.