Dorman 540-446 Suspension Stabilizer Bar Bushing Kit - Front

Dorman 540-446 Stabilizer Bar Bushing Kit

Dorman 540-446 is a front suspension stabilizer bar bushing kit built as a standard replacement for specific Mitsubishi applications. It is precision-engineered and tested to match the original equipment fit on the vehicles listed below.

Key Features

• Rubber and elastomer construction for suspension bar support
• Inside diameter: 25.5 mm
• Outside diameter: 47.5 mm
• Assembled length: 36 mm
• Bracket included: No
• Grease fitting included: No
• Standard replacement grade

Application Details

Compatible with 2004-2006 Mitsubishi Lancer, front, and 2003-2006 Mitsubishi Outlander, front. If you are searching for a front stabilizer bar bushing kit for Mitsubishi Lancer or Mitsubishi Outlander suspension service, Dorman 540-446 is the OE-style replacement to compare against the original part.

This part cross-references MOOG Chassis Products K200261 for the same application.

What It Helps Address

• Excessive sway bar movement at the front suspension
• Clunking or rattling from worn stabilizer bar bushings
• Loose-feeling front-end handling caused by bushing wear
• Noise from deteriorated rubber suspension bushings

Installation Notes

Verify the inside diameter, outside diameter, and assembled length against the original bushing before installation. This kit does not include a bracket or grease fitting. Confirm front-position fitment for 2004-2006 Mitsubishi Lancer and 2003-2006 Mitsubishi Outlander before ordering.

Quality Assurance

Dorman manufactures this stabilizer bar bushing kit as a tested replacement part for specific OE applications. The design focuses on dimensional accuracy and consistent material performance for routine suspension repair.