Dorman 540-671 Suspension Stabilizer Bar Bushing Kit - Front

Dorman 540-671 Front Stabilizer Bar Bushings

Dorman 540-671 is a front suspension stabilizer bar bushing kit built for specific heavy-duty Ford applications. It uses rubber/elastomer construction with a black finish and standard replacement grade to restore sway bar support and help maintain consistent front-end control.

Key Features

• Precision-engineered replacement for the original stabilizer bar bushings
• Rubber and elastomer material for OE-style fit and function
• Black finish
• Inside diameter: 27 mm; outside diameter: 38.1 mm
• Specific fit for selected Ford Super Duty front suspension applications
• Part number: 540-671

Detailed Description

This Dorman suspension stabilizer bar bushing kit is made for front suspension service on 2008-2016 Ford F-250 Super Duty, 2011-2016 Ford F-350 Super Duty with no extended axle (Fatboy option), and 2008-2010 Ford F-350 Super Duty with single rear wheel (SRW). It is engineered and tested as a standard replacement for the original equipment bushing design, helping maintain proper sway bar location and front suspension response. If you are replacing worn front sway bar bushings on a Ford F-250 Super Duty or Ford F-350 Super Duty, Dorman 540-671 provides a direct-fit service part for the listed applications.

This part cross-references MOOG Chassis Products K200884 for the same application.

What It Helps Address

• Front suspension clunking or rattling from worn stabilizer bar bushings
• Excess sway bar movement caused by deteriorated rubber bushings
• Loose or inconsistent front-end feel on Ford Super Duty trucks
• Noise from bushing wear at the stabilizer bar mounting points
• Replacement needs for OE-style front sway bar support

Installation Notes and Tips

Confirm the vehicle configuration before ordering, especially axle and rear wheel setup on Ford F-350 Super Duty models. Inspect the stabilizer bar and mounting surfaces for wear or corrosion before installation. Mounting hardware is not included, so reuse or replace hardware as needed based on condition. Verify the bushing dimensions and front position match the vehicle application before service.

Quality Assurance

Dorman designs this part as a tested replacement for the original equipment stabilizer bar bushing on the listed vehicles. The specific-fit design and standard replacement construction support consistent installation on the confirmed Ford Super Duty applications.