Dorman 542-245 Suspension Stabilizer Bar Link Kit - Front Left

Dorman 542-245 Rear Stabilizer Link Kit

Dorman 542-245 is a rear suspension stabilizer bar link kit built as a direct replacement for the original equipment link on select INFINITI applications. It is precision-engineered and tested for dependable fit and function, with greaseable construction, polymer bearings, and a coated finish for service-focused durability.

Key Features

• Rear suspension stabilizer bar link kit for the front left position on select vehicles
• Fits 2014-2024 INFINITI Q50, front left
• Fits 2017-2022 INFINITI Q60, front left
• Fits 2014-2019 INFINITI Q70, front left
• Fits 2015-2019 INFINITI Q70L, front left
• Fits 2014-2017 INFINITI QX50, front left
• Fits 2007-2008 INFINITI G35, front left
• Threaded end design with male threaded end connection
• Greaseable design with grease fitting included
• Dust boot included for added joint protection
• Polymer bearing material with locking nuts included
• Standard replacement grade with coated finish

Detailed Description

Dorman 542-245 is a suspension stabilizer bar link kit engineered for select INFINITI models, including Q50, Q60, Q70, Q70L, QX50, G37, G35, M37, M56, EX35, EX37, G25, and Q40 applications. This part number is a direct-fit replacement for the front left side and is built to restore stabilizer bar connection performance on vehicles such as the INFINITI Q50 and INFINITI G37. The design uses threaded connections, a polymer bearing, and a greaseable joint layout to support serviceability and consistent suspension operation.

This part cross-references MOOG Chassis Products (e.g., K750187, K750210) for the same application.

Common Issues This Part Can Address

• Clunking or rattling from the front suspension over bumps
• Excess play in the stabilizer bar link connection
• Worn or damaged link joints on the front left side
• Reduced stabilizer bar response during cornering
• Noise caused by deteriorated dust protection at the joint

Installation Notes and Tips

Verify vehicle fitment by year, model, and front left position before installation. The link uses threaded ends with 14 mm attachment sizes and a 1.25 mm bolt thread pitch, so confirm fastener compatibility during service. Because this kit is not pre-greased, apply the correct grease during installation if required by your service procedure. Always inspect the stabilizer bar, mounting points, and adjacent suspension components for wear before replacing the link.

Quality Assurance

Dorman designs this stabilizer bar link kit as a standard replacement part and subjects it to precision engineering and testing to support reliable OE-style service on the listed INFINITI applications.