Dorman 615-004CD Spindle Nut - Rear

Dorman 615-004CD Rear Spindle Nut for Ford Focus

Dorman 615-004CD is a steel rear spindle nut engineered for select Ford Focus applications from 2000-2011. It addresses the thread wear issue seen on certain original nuts by using a revised thread design that helps reduce repeat failure in service.

Key Features

• Steel construction for drivetrain and axle hardware applications
• Fine thread design with M20 x 1.50 thread size
• 30 mm hex size and 6-point drive
• One-time-use spindle nut design
• OE FIX replacement for rear wheel-end service on Ford Focus models
• Part number 615-004CD for direct identification

Detailed Description

This Dorman spindle nut is built for rear wheel-end service on the Ford Focus and is intended to replace the original nut used in applications where the factory multi-layer thread design can become damaged or stripped over time. The redesigned thread profile helps address a common failure point while maintaining the required M20 x 1.50 fine-thread specification. If you are servicing a Ford Focus rear hub or axle assembly, Dorman 615-004CD provides a direct-fit hardware solution for the listed model years.

This part cross-references Ford OE part number FS4Z3B477A for the same application.

What It Is Used For

• Replacing a stripped or worn rear spindle nut on a Ford Focus
• Restoring proper axle nut retention during rear wheel-end service
• Addressing thread damage found during hub or bearing work
• Supporting repair of rear driveline hardware on 2000-2011 Ford Focus models

Installation Notes and Tips

Fits 2000-2011 Ford Focus, rear. Confirm the thread size, hex size, and one-time-use requirement before installation. Because this is a spindle nut, follow the vehicle service procedure and torque specification for the rear hub or axle assembly. Inspect the mating threads and related wheel-end components for wear before reassembly.

Quality Assurance

Dorman OE FIX parts are engineered to revise known failure points in original equipment designs. Part number 615-004CD is built to the stated M20 x 1.50 thread specification and application requirements for the listed Ford Focus rear fitment.