Dorman 622-064 Brake Hydraulic Hose - Front Left

Brake Hose for Lifted Jeep Wrangler

Dorman 622-064 is a front left brake hydraulic hose for 1990-1995 Jeep Wrangler models with a braided steel line. It is 4 inches longer than the original equipment hose to accommodate raised suspension setups, while the braided stainless steel outer layer adds protection for off-road use.

Built for Jeep Wrangler front brake service, this hose includes a breakaway hose hanger clip that is engineered to release if the line snags an obstacle on the trail. That helps reduce the risk of brake fluid pressure loss in demanding driving conditions.

Key Features

• Fits 1990-1995 Jeep Wrangler, front left
• Part number 622-064
• 4 inches longer than OE for lifted suspension applications
• Braided stainless steel protection for added durability
• DOT approved brake hydraulic hose
• Includes a special breakaway hose hanger clip
• Includes brake hose mounting hardware and seals as listed

Detailed Description

This Dorman brake hydraulic hose is engineered for Jeep Wrangler owners who need extra length after a suspension lift. The hose uses a braided stainless steel sheath over a flexible brake line design to help resist trail debris and abrasion, while the extended length supports front left brake routing on lifted vehicles. Dorman 622-064 is a direct-fit service part for 1990-1995 Jeep Wrangler front left brake hose replacement.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems It Can Help Solve

• Front brake hose tension after a Jeep Wrangler lift
• Cracked, worn, or damaged hydraulic brake line
• Brake hose abrasion from off-road obstacles
• Routing issues caused by increased suspension travel
• Brake fluid pressure loss from a snagged hose

Installation Notes and Tips

Verify front left routing before installation and inspect the full brake line path for interference at full suspension droop and steering travel. Replace any worn sealing surfaces during service and confirm all fittings are tightened to the vehicle manufacturer’s specifications. After installation, bleed the brake system and check for leaks before returning the vehicle to service.

Quality Assurance

This brake hose is DOT approved and built with steel fittings, EPDM rubber outer sleeve material, and a braided protective jacket for added durability in demanding driving conditions.