Dorman 622-068 Brake Hydraulic Hose - Rear Center

Dorman 622-068 Brake Hose for Lifted Jeep

Dorman 622-068 is a braided stainless steel brake hydraulic hose for lifted Jeep Grand Cherokee applications. It is built 4 inches longer than the original equipment hose to accommodate raised suspension setups on the rear center position of 1993-1998 Jeep Grand Cherokee models.

For Jeep Grand Cherokee brake hose replacement needs, this Dorman 622-068 hose combines a flexible PTFE inner construction with a braided stainless steel jacket and EPDM outer sleeve for added protection in off-road use. It is DOT approved and includes a hose hanger breakaway clip plus zip ties for secure routing.

Key Features

• Fits 1993-1998 Jeep Grand Cherokee, rear center
• 4 inches longer than the original equipment hose for lifted suspension applications
• Braided stainless steel exterior for added resistance to trail debris and abrasion
• PTFE hose construction with steel end fittings and inverted flare connections
• DOT approved for road use
• Includes a special breakaway hose hanger clip and zip ties
• Silver finish with EPDM rubber outer sleeve

Detailed Description

This brake hydraulic hose is engineered for the rear center brake line on 1993-1998 Jeep Grand Cherokee models with raised suspension systems. The longer hose length helps maintain proper brake line routing after a lift, while the braided stainless steel jacket adds protection where off-road obstacles and suspension travel can stress the line. Dorman 622-068 uses steel female and male ends with 3/8-24 in thread sizes and inverted flare fittings for a direct-style brake hose replacement.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake hose tension after suspension lift installation
• Damage from trail debris, rocks, and suspension movement
• Routing issues caused by a hose that is too short for raised ride height
• Brake fluid pressure loss from a snagged or compromised hose
• Wear on the rear center brake line in off-road Jeep use

Installation Notes and Tips

Verify rear center fitment before installation on 1993-1998 Jeep Grand Cherokee models. Route the hose to avoid contact with moving suspension parts and sharp edges, and use the supplied hanger breakaway clip and zip ties to secure the line at the intended mounting points. After installation, inspect for leaks and confirm full suspension travel without hose interference.

Quality Assurance

Dorman 622-068 is DOT approved and built with steel fittings, a braided stainless steel jacket, and an EPDM outer sleeve for brake system service in demanding conditions. The design follows the stated fitment for lifted Jeep Grand Cherokee rear center applications.