Dorman 630-310 Drive Axle Shaft - Rear Right

OE Replacement Axle Shaft for Grand Cherokee

This Dorman drive axle shaft is a direct replacement for the original rear right axle on select Jeep Grand Cherokee models. Built for the 1999-2004 Jeep Grand Cherokee, it addresses axle shaft damage and bearing wear with application-specific components matched to the vehicle.

• Direct replacement drive axle shaft for the rear right position
• Fits 1999-2004 Jeep Grand Cherokee, rear right, Dana 35 axle
• Carbon steel construction for strength and durability
• 27-spline solid shaft axle design
• ABS tone ring installed for vehicles equipped with ABS
• Includes axle shaft, ABS tone ring, wheel studs, wheel nuts, bearing, and seal
• 30.24 in overall length
• 5-lug wheel pattern with 5 holes

Detailed Application Information

Dorman 630-310 is engineered as an OE-style axle shaft replacement for the rear right side of the Jeep Grand Cherokee with the Dana 35 axle. It is built from carbon steel and supplied with the bearing and seal needed for the application, along with the ABS tone ring already installed. This part number, 630-310, is a practical solution when the original axle shaft is damaged, the bearing surface is worn, or ABS-related axle components need replacement. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear axle shaft damage from wear, impact, or corrosion
• Noise or vibration caused by a worn axle bearing
• ABS warning concerns related to a damaged tone ring
• Wheel-end looseness from failed axle support components
• Driveline issues on the rear right side of a Jeep Grand Cherokee

Installation Notes and Tips

Verify Dana 35 axle configuration, rear right position, spline count, and overall length before installation. Confirm ABS tone ring and wheel lug specifications match the vehicle setup. Inspect the axle housing, seals, and bearing surfaces during service to help ensure proper fit and operation. The Dorman 630-310 should be installed using standard axle service procedures for the specific vehicle application.

Quality Assurance

Dorman supplies this axle shaft as a direct-fit replacement built to match the original equipment application on select Jeep Grand Cherokee models. The design focuses on correct fitment, included application-specific components, and OE-style replacement performance.