Dorman 630-312 Drive Axle Shaft - Rear Left or Rear Right

Dorman 630-312 Rear Axle Shaft for Jeep Cherokee

Dorman 630-312 is a direct replacement axle shaft for select 1996-2001 Jeep Cherokee models with a Chrysler axle. It is built for the rear left or rear right position and includes application-specific components needed for the installation. This axle shaft is a practical solution when the original shaft is damaged or the bearings are worn.

Key Features

• Direct replacement for the original axle shaft on select Jeep Cherokee applications
• Fits rear left and rear right positions on Chrysler axle-equipped vehicles
• Carbon steel construction for driveline durability
• Solid shaft axle design
• 29-spline configuration with 5-lug wheel pattern
• Includes axle shaft, wheel studs, wheel nuts, bearing, and seal
• Part number 630-312 for easy identification and ordering

Detailed Product Overview

This Dorman axle shaft is engineered for 1996-2001 Jeep Cherokee rear axle service where the OE shaft has failed or the bearing surface has worn. With a 29.82-inch length, 29 splines, and carbon steel construction, it matches the application requirements for Chrysler axle setups. The package includes the axle shaft, wheel studs, wheel nuts, bearing, and seal to support a complete repair. This part cross-references Monroe Shocks & Struts (e.g., 5018393AA, AXK250) for the same application. Dorman 630-312 is a fitment-based replacement for Jeep Cherokee rear axle repair work and is listed for both rear left and rear right positions.

Common Problems This Part Can Address

• Broken or damaged rear axle shaft
• Excessive noise from worn axle bearings
• Wheel vibration caused by axle wear
• Axle seal leakage at the rear axle assembly
• Loss of driveline integrity in Chrysler axle applications

Installation Notes and Tips

Verify axle type, spline count, length, and wheel lug configuration before installation. This part is listed for 1996-2001 Jeep Cherokee rear left and rear right positions with a Chrysler axle, so confirm the vehicle’s rear axle setup against the original component. The ABS tone ring is not included, so reuse or source the correct tone ring if your application requires one. Part number 630-312 should be matched to the vehicle identification and axle specifications before service.

Quality Assurance

Dorman supplies direct-replacement driveline components built to match specific vehicle applications. This axle shaft is designed to replace the original equipment on the listed Jeep Cherokee fitments and is supported by Dorman’s application-focused engineering approach.