Dorman 907-834 Engine Camshaft Position Sensor

Engine Camshaft Position Sensor for Mazda Applications

Dorman 907-834 is an engine camshaft position sensor built to match the fit and function of the original unit. It helps restore accurate camshaft position input to the engine control unit after the factory sensor has failed from heat exposure or internal component damage. Compatible With Mazda RX-8, Mazda Protege, Mazda Protege5, and Mazda RX-7 applications listed below.

Key Features

• Standard replacement camshaft position sensor for ignition and engine management systems
• Square, male connector with 2 terminals for OE-style electrical connection
• Black housing with a mounting bracket included
• 15V electrical specification
• Connector quantity: 1
• Wiring harness, wire lead, and mounting hardware are not included

Detailed Description

This Dorman camshaft position sensor, part number 907-834, is engineered for direct replacement use where the original sensor no longer sends reliable camshaft timing data. By restoring proper signal input, it supports accurate engine control operation on Mazda RX-8, Mazda Protege, Mazda Protege5, and Mazda RX-7 models covered by the fitment data. This part cross-references Standard Ignition PC193 and NTK EH0086 for the same application.

What It Helps Address

• Camshaft position sensor fault codes
• Hard starting or extended crank conditions related to sensor signal loss
• Intermittent stalling caused by inaccurate camshaft input
• Rough idle or drivability concerns tied to failed timing signals
• Check engine light illumination from sensor circuit issues

Installation Notes and Tips

• Verify connector shape, terminal count, and mounting style before installation.
• Inspect the harness connector for heat damage or corrosion before replacing the sensor.
• Clear diagnostic trouble codes after installation and confirm proper engine operation.
• Use the fitment list to confirm the correct Mazda RX-8, Protege, Protege5, or RX-7 application.

Quality Assurance

Dorman supplies standard replacement sensors designed to match original fit and function for service repair use. Part number 907-834 is built for the listed Mazda applications and follows OE-style replacement requirements for camshaft position signal restoration.