Dorman 926-174 Drive Axle Shaft Assembly - Rear Right

Dorman 926-174 Rear Right Axle Shaft Assembly

Restore rear driveline function on a 2001-2004 Toyota Sequoia with this Dorman OE FIX loaded axle shaft assembly. Part number 926-174 arrives with the critical components already assembled, helping reduce the time and equipment normally needed for a wheel bearing service.

Built for the rear right position, this axle assembly is a direct-fit solution for Toyota Sequoia models that need a complete replacement with the hub bearing, ABS tone ring, brake backing plate, and related axle components already in place.

Key Features

• Fits 2001-2004 Toyota Sequoia, rear right
• Loaded axle shaft assembly for a faster service process
• Hub bearing included for a complete rear axle repair
• ABS tone ring included for wheel speed signal function
• Brake dust shield and brake backing plate included
• Axle shaft seal included
• Rust-resistant coating helps protect the assembly
• Carbon steel shaft construction
• 6-lug x 139.7 mm wheel bolt pattern
• 30-spline inboard and 30-spline outboard configuration

Detailed Description

Dorman 926-174 is a drive axle shaft assembly engineered for the rear right side of the Toyota Sequoia from 2001 through 2004. It is a semi-float design with a 33.8 mm shaft diameter, 830 mm compressed length, and 12 mm x 1.5 wheel stud thread specification. The assembly includes the hub bearing, ABS tone ring, brake dust shield, brake backing plate, axle shaft seal, wheel studs, and the axle housing seal and O-ring listed in the package contents. This configuration supports a more complete axle service and reduces the need to press a worn bearing separately.

This part cross-references Toyota 4231134050 for the same application. Dorman 926-174 is a practical replacement choice when servicing a Toyota Sequoia rear axle that requires a loaded assembly rather than individual component replacement.

What This Part Helps Address

• Rear axle bearing noise or rough operation
• ABS tone ring wear or signal-related concerns
• Axle seal leakage at the rear housing
• Corrosion on the axle assembly or related hardware surfaces
• Brake backing plate or dust shield replacement during axle service

Installation Notes and Tips

Verify rear right fitment before ordering: this assembly is listed for 2001-2004 Toyota Sequoia, rear right. Confirm the 6-lug x 139.7 mm wheel bolt pattern, 30-spline axle configuration, and semi-float axle design match the vehicle being serviced. Because the assembly is loaded, it is suited to repairs where a complete rear axle service is preferred over rebuilding individual bearing components.

Quality Assurance

Dorman OE FIX parts are built to address common service challenges by combining the critical axle components into one assembly for a more straightforward repair process. Part number 926-174 is manufactured to support a direct replacement application for the specified Toyota Sequoia fitment.