Dorman 936-001 Drive Shaft - Rear

Dorman 936-001 Rear Driveshaft for Honda CR-V

Replace a worn rear driveline component with this complete Dorman drive shaft assembly for the 2002-2006 Honda CR-V, rear. Dorman 936-001 arrives pre-balanced and ready to install, with new yokes, tubes, CV joints, and universal joints already assembled for a direct replacement approach.

Key Features

• Complete rear driveshaft assembly for 2002-2006 Honda CR-V applications
• Pre-balanced for smoother driveline operation
• 100% new yokes, tubes, constant velocity joints, and universal joints
• Steel shaft construction
• 80.9 in drive shaft length with 2.5 in shaft diameter
• 0.065 in wall thickness
• Non-greaseable design
• Fixed-length assembly with no overall length adjustment

Detailed Description

Dorman 936-001 is a rear drive shaft assembly built for Honda CR-V driveline service where the original shaft has worn, vibrated, or developed joint-related noise. This steel assembly is supplied as a complete unit and is pre-balanced to support proper driveline rotation after replacement. It is a direct-fit solution for the rear position on 2002, 2003, 2004, 2005, and 2006 Honda CR-V models. This part cross-references Honda OE 40100S9AE01 for the same application.

For buyers searching for a 2002-2006 Honda CR-V rear driveshaft replacement, Dorman 936-001 provides the key dimensions and component layout needed for a straightforward service job. The assembly uses new tubes and joints rather than reusing worn driveline parts, which helps restore consistent power transfer through the rear driveline.

Common Problems This Part Can Address

• Driveline vibration from a worn or out-of-balance rear shaft
• Clunking or clicking from worn CV joints or universal joints
• Noise during acceleration or deceleration from driveline wear
• Corrosion or fatigue in the original steel shaft
• Loss of smooth rear driveline operation on Honda CR-V models

Installation Notes and Tips

Verify rear-position fitment before installation on your Honda CR-V. Compare the original shaft length, diameter, and mounting configuration to Dorman 936-001 before removal. Because this assembly is not adjustable, correct application matching is important for proper fit and driveline alignment. Inspect surrounding driveline components, mounts, and seals during service so the replacement shaft is installed into a clean, serviceable system.

Quality Assurance

Dorman supplies this rear driveshaft as a complete replacement assembly with new internal wear components and pre-balanced construction. Part number 936-001 is built to match the listed 2002-2006 Honda CR-V rear application and support a direct replacement repair.